Bedienungsanleitung Alpine CDE-104BTI (Seite 6 von 39) (Englisch)

60768

Zoom out

Zoom in

Vorherige Seite

1/39

Nächste Seite

4-EN

Never Attempt the Following

Do not grip or pull out the disc while it is being pulled back into the

player by the automatic reloading mechanism.

Do not attempt to insert a disc into the unit when the unit power is

off.

Inserting Discs

Your player accepts only one disc at a time for playback. Do not

attempt to load more than one disc.

Make sure the label side is facing up when you insert the disc.

“ERROR” will be displayed on your player if you insert a disc

incorrectly. If “ERROR” continues to be displayed even though the

disc has been inserted correctly, push the RESET switch with a

pointed object such as a ballpoint pen.

Playing a disc while driving on a very bumpy road may result in

skips, but this will not scratch the disc or damage the player.

New Discs

To prevent the CD from jamming, “ERROR” is displayed if discs

with irregular surfaces are inserted or if discs are inserted

incorrectly. When a new disc is ejected immediately after initial

loading, use your finger to feel around the inside of the centre hole

and outside edge of the disc. If you feel any small bumps or

irregularities, this could inhibit proper loading of the disc. To

remove the bumps, rub the inside edge of the hole and outside edge

of the disc with a ballpoint pen or other such instrument, then insert

the disc again.

Irregular Shaped Discs

Be sure to use round shape discs only for this unit and never use

any special shape discs.

Use of special shape discs may cause damage to the mechanism.

Installation Location

Make sure this unit will not be installed in a location subjected to:

• Direct sun and heat

• High humidity and water

• Excessive dust

• Excessive vibrations

Correct Handling

Do not drop the disc while handling. Hold the disc so you will not

leave fingerprints on the surface. Do not affix tape, paper, or

gummed labels to the disc. Do not write on the disc.

Disc Cleaning

Fingerprints, dust, or soil on the surface of the disc could cause the

CD player to skip. For routine cleaning, wipe the playing surface

with a clean, soft cloth from the centre of the disc to the outer edge.

If the surface is heavily soiled, dampen a clean, soft cloth in a

solution of mild neutral detergent before cleaning the disc.

Disc Accessories

There are various accessories available on the market for protecting

the disc surface and improving sound quality. However, most of

them will influence the thickness and/or diameter of the disc. Using

such accessories can cause the disc to be out of standard

specifications and may create operational problems. We

recommend not using these accessories on discs played in Alpine

CD players.

Centre Hole

Bumps

Centre Hole

New Disc

Outside

(Bumps)

CORRECT

INCORRECT CORRECT

Transparent Sheet Disc Stabilizer

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Alpine CDE-104BTI Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Alpine CDE-104BTI

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info