471374
34
Zoom out
Zoom in
Vorherige Seite
1/41
Nächste Seite
34-EN
In Case of Difficulty
If you encounter a problem, please turn the power off, then on again. If
the unit is still not functioning normally, please review the items in the
following checklist. This guide will help you isolate the problem if the
unit is at fault. Otherwise, make sure the rest of your system is properly
connected or consult your authorized Alpine dealer.
No function or display.
Vehicles ignition is off.
If connected following instructions, the unit will not operate with
the vehicle’s ignition off.
Improper power lead (Red) and battery lead (Yellow) connections.
Check power lead and battery lead connections.
•Blown fuse.
Check the fuse of the unit; replace with the proper value if
necessary.
Internal micro-computer malfunctioned due to interference noise
etc.
Press the RESET button with a ballpoint pen or other pointed
article.
Unable to receive stations.
No antenna or open connection in cable.
Make sure the antenna is properly connected;
replace the antenna or cable if necessary.
Unable to tune stations in the seek mode.
You are in a weak signal area.
Make sure the tuner is in the DX mode.
If the area you are in is a primary signal area, the antenna may not be
grounded and connected properly.
Check your antenna connections; make sure the antenna is
properly grounded at its mounting location.
The antenna may not be the proper length.
Make sure the antenna is fully extended; if broken, replace the
antenna with a new one.
Broadcast is noisy.
The antenna is not the proper length.
Extend the antenna fully; replace it if it is broken.
The antenna is poorly grounded.
Make sure the antenna is grounded properly at its mounting
location.
CD Player not functioning.
Out of operating temperature range +50°C (+120°F) for CD.
Allow the vehicles interior (or trunk) temperature to cool.
CD playback sound is wavering.
Moisture condensation in the CD Module.
Allow enough time for the condensation to evaporate (about
1 hour).
CD insertion not possible.
A CD is already in the CD player.
Eject the CD and remove it.
The CD is being improperly inserted.
Make sure the CD is being inserted following instructions in the
CD Player Operation section.
Unable to fast forward or backward the CD.
The CD has been damaged.
Eject the CD and discard it; using a damaged CD in your unit can
cause damage to the mechanism.
CD playback sound skips due to vibration.
Improper mounting of the unit.
Securely re-mount the unit.
•The disc is very dirty.
–Clean the disc.
The disc has scratches.
Change the disc.
The pick-up lens is dirty.
Do not use a commercially available lens cleaner disc. Consult
your nearest Alpine dealer.
CD playback sound skips without vibration.
The disc is dirty or scratched.
Clean the disc; damaged disc should be replaced.
Error displays (built-in CD player only).
Mechanical error
–Press . After the error indication disappears, insert the disc
again. If the above-mentioned solution does not solve the problem,
consult your nearest Alpine dealer.
CD-R/CD-RW playback not possible.
Close session (finalisation) has not been performed.
Perform finalisation and attempt playback again.
MP3 is not played back.
Writing error occurred. The MP3 format is not compatible.
Make sure the MP3 has been written in a supported format. Refer
to “About MP3” on page 15, then rewrite in the format supported
by this device.
The sound is not output from the speakers.
Unit has no output signal of the internal amplifier.
POWER IC is switched to “POW ON”, refer to “Connecting to an
External Amplifier (POWER IC)” on page 18.
iPod does not play and no sound is output.
The iPod has not been recognised.
Reset this unit and the iPod. Refer to “Initial System Start-Up” on
page 9. To reset the iPod, refer to the Owner’s Manual of the iPod.
No CD is inserted.
Insert a CD.
Although a disc is inserted, “NO DISC” is displayed and the unit does
not start to play or eject the disc.
Remove the disc by following these steps:
Press the button again for at least 2 seconds.
If the disc still does not eject, consult your Alpine dealer.
Information
Basic
Radio
CD
MP3
Audio
iPod
Indication for CD Player
34

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

alpine-cde-133bt

Suche zurücksetzen

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Alpine CDE-133BT wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Alpine CDE-133BT

Alpine CDE-133BT Bedienungsanleitung - Deutsch - 46 seiten

Alpine CDE-133BT Bedienungsanleitung und Installationsanweisung - Holländisch - 46 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info