471435
28
Zoom out
Zoom in
Vorherige Seite
1/39
Nächste Seite
ALPINE HCE-C300R_EN 68-18693Z26-B (A5)
26-EN
Calibration
Introduction
What is Calibration?
In order to effectively identify approaching
objects, it is necessary to configure the guidance
and install data. This data is entered during the
Calibration mode and ensures the most consistent
detection results.
Also, the warning message language and the cm/
inch selection can be set in the Calibration mode.
Recalibration is required whenever the camera
position is changed or the camera is installed in a
different vehicle.
If this camera system is used without being
calibrated, or if the calibration sheet is not installed
correctly, object detection performance will be
degraded. Calibration must be performed.
If the vehicle height changes after calibration, the
system must be re-calibrated.
Be sure the shift gear lever is in the P position and
apply the hand brake before starting work.
Do not operate the gear lever during calibration.
Always work in a flat location.
When starting the engine, provide adequate
ventilation around the car.
Make sure that all connections are securely made.
Do not work in a poorly lit place or in direct sunlight.
Setting Flowchart
Use the switch to perform calibration.
After connecting the camera system with the
navigation/monitor, prepare the car body.
Affix the calibration sheet.
Set the SETUP switch of the control unit to
ON.
Set ACC to “ON”.
Perform calibration of the camera.
Set ACC to “OFF”.
Set the SETUP switch of the control unit to
OFF.
Setting ACC to “ON” activates the system in
the normal use mode.
Switching between Calibration
Mode” and “Normal Use Mode”
HCE-C300R has two modes: “Normal Use Mode
and “Calibration Mode.” You can use the SETUP
switch on the control unit to switch the mode. If
ACC is set to ON with the SETUP switch “ON”,
the system starts in the calibration mode, and if
ACC is set to ON with the SETUP switch “OFF”,
the system starts in the normal use mode. The
factory setting is “OFF”.
Preparation
Accessory parts
Calibration sheet A Calibration sheet B
External box Interior box
Necessary tools
Tape measure Adhesive tape (for
positioning mark)
Pen (for positioning
mark)
Nec
Keep
Pre
Ch
un
pre
Be
and
Wh
to p
Ma
for
Wo
dri
Th
to t
how
Wh
cha
Th
tire
item
Aff
Affix
came
1
28

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Alpine HCE-C300R wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info