Bedienungsanleitung Amana NTW4600YQ (Seite 10 von 32) (Englisch, Französisch)

506797

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

REINSTALLING/USING WASHER AGAIN

To reinstall washer after non-use, vacation, winter storage,

or moving:

1. Refer to “Installation Instructions” to locate, level, and

connect washer.

2. Before using again, run washer through the following

recommended procedure:

To use washer again:

1. Flush water pipes and hoses. Reconnect water inlet hoses.

Turn on both water faucets.

2. Plug in washer or reconnect power.

3. Run washer through Casual Regular cycle to clean washer

and remove antifreeze, if used. Use half the manufacturer’s

recommended amount of detergent for a medium-size load.

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death,

re, or electrical shock.

WARNING

TROUBLESHOOTING

If you experience Possible Causes Solution

Vibration or Off-Balance

Check the following for

proper installation or see

“Using Your Washer”

section

Feet may not be in contact with the

oor and locked.

Front and rear feet must be in rm contact with oor, and washer

must be level to operate properly. Jam nuts must be tight against

the bottom of the cabinet.

Washer may not be level. Check oor for exing or sagging. If ooring is uneven, a 3/4"

(19 mm) piece of plywood under your washer will reduce sound.

See “Level the Washer” in Installation Instructions.

Load could be unbalanced. Load dry garments in loose heaps evenly around basket wall.

Adding wet garments to washer or adding more water to basket

could unbalance washer.

Wash smaller loads to reduce imbalance.

Do not tightly pack. Avoid washing single garments.

Use the Normal Regular cycle and select Large Load Size for

oversized, non-absorbent garments such as comforters or

poly-lled jackets.

See “Cycle Guide” and “Using Your Washer.”

Noises

Clicking or

metallic noises

Objects caught in washer

drain system.

Empty pockets before washing. Loose items such as coins

could fall between basket and tub or may block pump. It may be

necessary to call for service to remove items.

It is normal to hear metal items on clothing such as metal snaps,

buckles, or zippers touch against the basket.

Gurgling or humming Washer may be draining water. It is normal to hear the pump making a continuous humming

sound with periodic gurgling or surging as nal amounts of water

are removed during the Drain/Spin cycles.

Humming Load sensing may be occuring. You may hear the hum of the sensing spins after you have

started the washer. This is normal.

First try the solutions suggested here or visit our website at www.amana.custhelp.com -

In Canada www.amanacanada.ca for assistance and to possibly avoid a service call

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Amana NTW4600YQ Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info