Bedienungsanleitung Ambrogio L400 Elite (Seite 15 von 42) (Englisch)

733772

Zoom out

Zoom in

Vorherige Seite

1/42

Nächste Seite

User’s manual

Marking the boundary of the work area

3. Check the entire lawn surface and assess whether it is

necessary to divide it into separate work areas as per the

rules described here below. Before installing the perimeter

wire, check the entire path to make this procedure easier. The

illustration shows a lawn with the track for installation of the

perimeter wire.

During installation, identify any secondary areas and closed

areas. A secondary area is part of a lawn connected to the

primary lawn with a passage that is difcult to reach by the

robot's normal movement. The area must be reachable without

any rises or drops greater than those allowed. Whether a

zone is to be dened a “secondary area” also depends on

the size of the primary area. The larger the primary area, the

harder it will be to reach narrow passages. More generally,

a passage narrower than 400 cm (157,48") is considered a

secondary area. The number of secondary areas managed

depends on the characteristics of the model (See “Technical

Specications”).

The minimum passage allowed is 200 cm (78,74") from

each edge of the perimeter wire. The perimeter wire must be

positioned at a distance of (to be indicated below) from any

objects outside the lawn; therefore, the necessary space for

passing must be 270 cm (106,30") if there is a wall or hedge

on both sides.

If this passage is very long, the width should be more than

200 cm ( 78,74") between perimeter wires.

During programming, it is necessary to congure the size of the

secondary areas as a percentage of the lawn, and the quickest

direction for reaching it (clockwise or counter-clockwise), as

well as the number of meters of wire needed to reach the

secondary area. See “Programming Mode.”

Track for laying

the perimeter wire

min. 200 cm / 78,74"min. 200 cm / 78,74"

min. 200 cm / 78,74"

corridor with a minimum passage

of 200 cm / 78,74" from edge to edge.

PRIMARY AREA

SECONDARY AREA

If the aforesaid minimum requirements are not met i.e. an area

separated by a rise or drop with characteristics that cannot be

managed by the robot or a passage (corridor) narrower than

200 cm ( 78,74") from perimeter edge to perimeter edge, then

this area of the lawn is considered a “Closed Area.” To mark a

“Closed Area” lay the outgoing and incoming perimeter wire in

the same track at a maximum distance of 1 cm (0.40 "). In this

case, the robot is unable to reach the area autonomously, and

must be managed as described in the chapter “Management

of Closed Areas.” The management of “Closed Areas” reduces

the square meters that can be managed autonomously by the

robot.

corridor with a passage

< 200 cm / 78,74"

PRIMARY AREA

CLOSED

AREA

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ambrogio L400 Elite Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Ambrogio L400 Elite

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info