Bedienungsanleitung American Audio 19 MXR (Seite 11 von 22) (Englisch)

603200

Zoom out

Zoom in

Vorherige Seite

1/22

Nächste Seite

leftsideofthemixer.Samples4-6arestoredunderCuebuttons1-3locatedontherightsideoftheboard.The

ControllerModeButtonLEDwillblinkwhentheSamplerisactive.

10. MASTER VOLUME LEVEL INDICATORS - ThedualMASTERLEVELLEDindicatorsareusedtodetailthe

masteroutputlevel.Themeterswilldetailtheoutputlevelofboththeleftandrightchannels.

11. CUE MIXING CONTROL - ThisfunctionsallowsyoutomonitortheCuelevelaswellastheProgram(main

output)levelinyourheadphones.AchannelsCueLevelmayonlybemonitoredifthechannelsCUE (4) func-

tionisselected.Toselectachannelscuefunctionpressthe CUE BUTTON (4) thatisdirectlyassociatedwith

thespecificchannelyouwishtomonitor.YoumayusethemixingfunctiontoblendboththeCuelevelandthe

Programleveltogether.Youcanvarytheoutputleveltoeitherhearmoreorlessofeitherofthetwolevels.

TurningtheCueMixingknobtotheCUEposition(left)willallowyoutohearmoreoftheCuelevel.Turningthe

knobtothePGM position(right)willallowyoutohearmoreoftheProgramlevel(mainoutput).Youmayalso

usetheCueMixingControltoheareithertheCuelevelortheProgramlevelexclusively.Iftheknobisinthe

fullCUEpositionyouwillonlyhearthecuelevel,iftheknobisinthefullPGMpositionyouwillonlyhearthe

mainoutput.Thisfunctionisespeciallyusefulwhenmixingwithoutanmonitor.

12. HEADPHONE JACK - Thisjackisusedtoconnectyourheadphonestothemixerallowingyoutomonitor

thecuesource.Useheadphonesonlyratedat8ohmsto32ohms.MostDJheadphonesareratedat16ohm,

thesearehighlyrecommended.AlwaysbesuretheCUE LEVEL VOLUME (6) issettominimumbeforeyouput

theheadphoneson.

13. CHANNEL VOLUME FADER - Thesefadersareusedtocontroltheoutputsignalofanysourceassigned

toitsparticularchannel.However,mastervolumeiscontrolledbythe MASTER VOLUME CONTROL (7).

14. FEATHER FADER PLUS CROSSFADER - Thisfaderisusedtoblendtheoutputsignalsofchannelsone

andtwotogether.Whenthefaderisinthefullleftposition(channel1),theoutputsignalofchannelonewillbe

controlledbythemastervolumelevel.Thesamefundamentalswillapplyforchanneltwo.Slidingthefaderfrom

onepositiontoanotherwillvarytheoutputsignalsofchannelsoneandtworespectively.Whenthecrossfader

issetinthecenterposition,theoutputsignalsofboththechannelsoneandchannelstwowillbeeven.

15. FADER ASSIGN KNOB - This knob assigns a channel to the CROSSFADER (14). When a channel is

assignedtotheleftsideoftheCROSSFADER (14) thatchannelsoutputlevelisroutedtoandcontrolledbythe

CROSSFADER (14).SlidingtheCROSSFADER (14)toleftpositionwillsendthevolumeoutputoftheassigned

channel tothe MASTER VOLUME LEVEL (7), sidingtheCROSSFADER (14) torightpositionwillcutthatchan-

nels volume to MASTER VOLUME LEVEL (7). Thereverseistruefortherightchannelfaderassignswitch.When

theassignswitchissettothe“OFF”positionthecrossfaderwillhavenofunction.

16. CROSSFADER CURVE ADJUSTMENT - Thisrotaryknobisusedtochangethewaythecrossfaderwill

operate.Thecrossfadercanoperateindifferentmodes,“NORMALCURVE”,“QUICKCURVE”oranyvariation

ofthetwo.(QuickCurveusuallyusedforscratching).

17. CUE, SYNC, PITCH BEND, & PLAY/PAUSE -

CUE 1, 2, & 3 - These buttons will set or trigger hot cue 1, 2, or 3.

DELETING HOT CUE POINTS - If a hot cue point is set, it is indicated by a lit Cue button LED. If you wish

to delete a hot cue point, press the Shift button. The shift button LED will ash along with the Cue LEDs.

Press the Cue button that contains the hot cue you wish to delete. After, press the Shift button again to

disable the soft shift..

PITCH BEND - To perform temporary pitch bends in Virtual DJ, hold the Shift button and Cue 1 to slow the

track. To speed up the track hold the Shift button and press the Cue 3 button. To reset the pitch, hold the

Shift button and press Cue 2.

SYNC - Will sync the selected deck to the opposite deck or master deck/tempo.

CUE - When the deck is playing, pressing this button will return to the 1st cue point. If the deck is

paused, pressing Cue will set a new cue point.

19MXR CONTROLS AND FUNCTIONS cont.

American Audio 19 MXR Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von American Audio 19 MXR

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info