Bedienungsanleitung Amica EGSP 14387 V (Seite 24 von 30) (Englisch)

751254

Zoom out

Zoom in

Vorherige Seite

1/30

Nächste Seite

Positioning the Appliance

How to Drain Excess Water From Hoses

If the sink is 1000 higher from the floor, the excess water in hoses cannot be drained directly

into the sink. It will be necessary to drain excess water from hoses into a bowl or suitable

container that is held outside and lower than the sink.

Water Outlet

Connect the water drain hose. The drain hose must be correctly fitted to avoid water leaks.

Ensure that the water inlet hose is not kinked or squashed.

The following things should be checked before starting the dishwasher.

Syphon Connection

Insert the drain hose into a drain pipe with a minimum diameter of 40mm, or let it run into the sink, making sure to

avoid bending or crimping it. The top of the hose must be less than 1000mm.

The content of this manual is very helpful to the users.

After installation, please make sure to keep this manual.

Extension Hose

If you need a drain hose extension, make sure to use a similar drain hose.

It must be no longer than 4 metres; otherwise the cleaning effect of the dishwasher could be reduced.

1The dishwasher is level and fixed properly

2The inlet valve is open

3There is a leakage at the connections of the conducts

4The wires are tightly connected

5The power is switched on

6The inlet and drain hoses are knotted

7All packing materials and printings should be taken out from the dishwasher

Position the appliance in the desired location. The back should rest against the wall behind it, and the sides,

along the adjacent cabinets or walls.The dishwasher is equipped with water supply and drain hoses that can

be positioned either to the right or the left sides to facilitate proper installation.

Please close the hydrant after using.

Turn off the water.

Release the water pressure by depressing the pressure release button. This relieves water pressure and protects you, and

the room, from severe splashing.

Unscrew The safety supply hose from the faucet..

Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure that it is fastened tightly in place.

If the water pipes are new or have not been used for an extended period of time, let the water run to make sure that the

water is clear and free of impurities. If this precaution is not taken, there is a risk that the water inlet can get blocked and

damage the appliance.

A hose that attaches to a sink spray can burst if it is installed on the same water line as the dishwasher. If your sink has one, it

is recommended thet the hose be disconnected and the hole plugged.

The safety supply hose consists of the double walls. The hose's system guarantees its intervention by blocking the flow of water

in case of the supply hose breaking and when the air space between the supply hose itself and the outer corrugated hose is full

of water.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Amica EGSP 14387 V Seite 24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Amica EGSP 14387 V

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info