Bedienungsanleitung Amica FC2063 (Seite 9 von 20) (Englisch)

795012

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

Minimum distances from the heat

sources

- from the electric gas and other

ovens - 30 mm,

- from oil or coal red ovens - 300

mm,

- from built-in ovens - 50 mm

If there is no possibility of ensuring the above- men-

tioned distances, provide an appropriate insulation

board.

The rear wall of the refrigerator, in particu-

lar, the condenser and other elements of

the cooling system must not contact other

elements, which may damage them, (e.g.

central heating pipes and the water supply

pipes).

It is forbidden to readjust or modify any

parts of the unit. It is crucial not to damage

the capillary tube visible in the compressor

recess. The tube may not be bent, straigh-

tened or wound.

If the capillary tube is damaged by the user

the guarantee will be void (g. 5).

Mains connection

lBefore the appliance is connected to the

mains, set the adjustment knob to the "OFF"

/ “0” position.

lThe appliance is intended for connection to alter-

nating current. The connection values for voltage

(V) and frequency (Hz) are given on the name-

plate in the cabinet.Power must be connected via

a wall socket with switch. The wall socket should

be easily accessible.All earthing requirements

stipulated by the local electricity authority must be

observed. The cabinet plug and wall socket should

then give correct earthing. If in doubt, contact your

local supplier or an authorised electrician.

This appliance must be earthed

The exible cord (mains lead) tted to

this appliance has three cores for use

with a 3-pin 13-amp plug. If a BS 1363

(13-amp) fused plug is used, it should

be tted with a 13-amp fuse.

lIf an extension lead is used (with a protec- tion ring

and safety certicate), its socket must be located

at a safe distance, away from the sinks, and must

not be in a place where it could be ooded by

water or waste water.

lThe data is provided on the rated plate located at

the bottom of the wall inside the chamber.

l On the exterior surface of the product may be a

protective foil, this foils should be removed.

l Make sure the appliance is placed in a horizontal

position by screwing in the 2 adju- stable front legs

(g. 3)

l In order to ensure easy opening of the door,

the distance between the side wall of the

appliance (from the side of the door hinges),

and the wall should amount to: 70 mm. (for

appliances with external handle) and 50 mm

(for appliances with recessed handle).

l Ensure adequate ventilation of the room and free

air circulation from all sides of the appliance (g.

4).

In some models the handle is put into

the appliance, You should screw it with

Your own screwdriver (Fig. 16).

Important

The cores in this mains lead are coloured in accord-

ance with the following code:

GREEN-AND-YELLOW: EARTH

BLUE: NEUTRAL

BROWN: LIVE

These colours might not correspond with the colour

markings identifying the terminals in your plug (g.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Amica FC2063 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info