Bedienungsanleitung Amica FS1503 (Seite 11 von 20) (Englisch)

795031

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

OPERATION AND FUNCTIONS

Control panel (Fig. 10).

1. Red LED- Shows that the appliance is supplied with electric energy.

2. Green LED- Shows that the compressor is working.

3. Temperature adjustment knob

Temperature adjustment

Turning the knob to a different setting changes the temperature in the fridge-freezer.

Available knob settings:

• appliance switched off - OFF setting

• maximum temperature - 1 setting

• optimal temperature - 2-4 setting

• minimum temperature - setting

Do not put food into the fridge freezer befo-

re it has reached its operating temperature,

which takes minimum 4 hours.

Temperature inside the fridge / freezer chamber

Do not change the temperature settings due to the change in the season of the year. The ambient tem-

perature increase will be detected by the sensor and the compressor will be switched on automatically

for a longer period of time in order to maintain the temperature set inside the chambers.

Minor changes in temperature

The slight changes in temperature are perfectly normal and may occur, for instance during the storage

of great quantities of fresh products in the fridge, or when the door is open for a longer period of time.

This will not affect the condition of the stored foodstuff, and the temperature will quickly return to its set

value.

Replace the light bulb*

● Set the knob to „OFF”, then unplug the appliance.

● Remove the bulb cover (Fig. 18).

● Replace the bulb with one having identical parameters as the bulb factory pre-installed in the ap-

pliance (E14 thread, 220-240V, max 10W, maximum dimensions: diameter 26 mm, length 55 mm).

● Replace the bulb cover.

Bulbs of a higher or lower power should not be used, only use bulbs of the specication given

above.

The light bulb must not be used for room illumination.

* Applicable to appliances factory designed for incandescent lighting, and selected appliances equip-

ped with LED lighting in the form of a E14 thread light bulb.

In order to defrost the freezer chamber, you must take the following steps (Fig. 20):

● Set the knob at ”OFF” / "0" position, take out the plug from the mains socket.

● Open the lid and remove the food from the freezer.

● After about 0.5h, it is possible to remove the white frost or water from the smooth wall surfaces.

● There is a water conduit at the bottom of the freezer, when defrosting, extract the rubber cover,

defrosted water will drip into the hole and ow out. (NOTES: PLEASE KEEP THE RUBBER COVER

WELL DURING THE DEFROSTING AND PUT IT BACK AFTER DEFROSTING IS DONE )

● Extract the water conduit by 20-25mm until the water hole can be seen.

● Twist the water conduit until the arrow points downward.

● After defrosting is done, make sure there is no more water coming out before out the water conduit in

place and make the arrow point upward.

● Wash the interior of the freezer and wipe it dry.

● Switch on the appliance as per the relevant point in the manual.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Amica FS1503 Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info