Bedienungsanleitung Amica OSC 5458 I (Seite 4 von 4) (Englisch)

540025

Zoom out

Zoom in

Vorherige Seite

1/4

Nächste Seite

VI Operation and maintenance

1. Operational safety.

All safety instructions included in chapter IV must be observed. Textile grease filters and

carbon filters should be replaced and aluminium filter should be cleaned according to

manufacturer’s instructions, or more frequently in periods of intensive use (more than 4 hours

a day). If a gas cooker is used it is forbidden to leave uncovered flame. When removing pots

from gas burners set the flame to its minimum level. Always make sure that flame does not

extend outside the pot. Such a situation causes undesired energy losses and dangerous heat

build-ups. The hood should not be used for other purposes than those for which it was

designed.

2. Operation:

2.1 Control panel

Fig. 4

Operation of the hood can be controlled by means of switches „W” and „O” (Fig. 4):

- switch „O” controls lighting. Shifting the switch to the left turns the lighting on, to the right

- turns the lighting off.

- switch „W” is used to control the hood motor. Successive shifts to the left turn on three fan

operation speeds. These control options enable the user to set the optimum fan speed for his

requirements at minimum noise.

3. Maintenance.

Regular maintenance and cleaning of the device will guarantee its good and fault-less

operation, and extend its life. Attention should be paid to replacing grease and carbon filters

according to instructions.

3.1 Grease filter

a) replacement

The grease filter should be replaced at least every two

months during normal operation of the hood. The filter

can be dismantled by releasing its securing studs (Fig. 5),

keeping in mind that the filter has to be protected with

your hand during releasing the studs, removing catches D

which secure the filters (Fig. 6), then you can replace the

filter and reinstall the catches and the mesh.

Fig. 5

3.2 Carbon filter

a) operation

Carbon filters (C Fig. 6) can absorb odours

until they are saturated. They cannot be

washed or regenerated and should be

replaced at least every 2 months or more

frequently in case of very intensive use.

b) replacement

- remove masking cover A (Fig. 6) together

with grease filter B,

- replace carbon filter C situated on the

textile filter B,

Fig. 6

- install the grease filter with the carbon filter in the hood.

3.3 Lighting

The lighting system consists of 40 W power light bulb.

To replace a light bulb proceed as follows:

a) remove the masking cover A from the hood body (see section 3.1 a)

b) replace the bulb using a piece of cloth or paper for that purpose,

c) install the masking cover A.

3.4 Cleaning

When cleaning your hood never use:

- solvents or alcohols which might dull lacquered surfaces

- caustic or abrasive substances, particularly for cleaning stainless steel surfaces

It is recommended to us moist cloth and liquid neutral cleaning agents.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Amica OSC 5458 I Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info