794755
23
Zoom out
Zoom in
Vorherige Seite
1/28
Nächste Seite
23
EMERGENCY PROCEDURE
Every time when emergency situation occurs you should:
switch o󰀨 the working assemblies of the plate
disconnect power supply
call in the service
as some minor faults can be removed by the user in accordance with the be low specied
instructions, before calling the Customer Service please go thro ugh the Table checking
every point.
PROBLEM CAUSE ACTION
1.The appliance is not wor king - power supply failure -check the in-house electric sys tem
fuse, replace if ne ces sa ry
2. The appliance does not re spond to
the entered settings
-control panel has not been swit-
ched on
- switch it on
- sensors have been to uched for less
than one se cond
- touch the sensors for a bit lon ger
- several sensors have been to uched
at the same time
- always touch only one sen sor
(except when switching o󰀨 a hotplate)
3.The appliance does not re spond
and emits a short si gnal
- children lock has been
activated
- switch o󰀨 the children lock
4.The appliance does not re spond
and emits a long si gnal
-improper operation (im pro per sen sors
have been to uched or pro per sensors
have been touched for too short time
- again activate the plate
- covered or dirty sensor (sen sors) - uncover or clean the sen sors
5.The whole appliance swit ches o󰀨 - no settings have been en te red
within 10 seconds from swit ching
the plate on
- again switch on the control panel
and im me dia te ly enter the settings
- covered or dirty sensor (sen sors) - uncover or clean the sen sors
6. One heating zone switches o󰀨,
and ”H” is on the display.
- limited time of operation - again switch on the hot pla te
- covered or dirty sensor (sen sors) - uncover or clean the sen sors
7.Residual temperature in di ca tor is
not lighted although the hot pla tes
are still hot
- power supply fa ilu re, the ap plian-
ce has been di scon nec ted from the
mains
-the residual temperature in di ca tor
will work again after swit ching the
control panel on and o󰀨.
8. Crack in the ceramic plate Danger! Immediately disconnect the ceramic plate from the
mains (fuse) and call the nearest Customer Service Centre.
9. If the fault still remains Disconnect the ceramic plate from the mains (fuse) and call the nearest
Customer Service Centre.
Important!
You are the person responsible for proper condition and operation of the
appliance in your household. If you call the Service for a fault which re-
sulted from improper operation, you will be charged with the costs of the visit
even during the period of warranty. We shall not be held liable for damages
caused by a failure to observe this Manual.
23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Amica PH3200ZT wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info