Bedienungsanleitung Amica UKS 16158 (Seite 76 von 80) (Deutsch, Englisch, Holländisch, Französisch, Polnisch)

496064

Zoom out

Zoom in

Vorherige Seite

1/80

Nächste Seite

DOOR REVERSAL

6. Remove the two screws, which attach the lower hinge to the appliance door (Fig. 5). Take

special care and hold the appliance door with the other hand.

7. Holding the door, swing the lower door hinge away from the door using the other hand, then

detach the door from the appliance body (Fig. 6).

8. Remove the two screws , which attach the upper hinge to the body and the two screws hol-

ding the lower hinge to the appliance body (Fig. 7).

9. Screw the upper and lower hinge on the opposite side of the appliance body using suitable

screws (Fig. 8). Upper hinge should be mounted on the other side of the appliance as the lower

hinge. The lower hinge should be mounted on the other side of the appliance as the upper

hinge.

With the hinges open, hold the door parallel to the appliance body and screw the hinges to the

door using suitable screws while taking proper care.

10. Make sure that the door is properly aligned with the appliance body (Fig. 9).

INSTALLATION OF THE APPLIANCE

Installation of the appliance should be performed by a qualied installer. The appliance should be

placed in furniture case (Fig. 10). Once the appliance is placed correctly, adjust the height of the ap-

pliance by turning the 4 adjustable feet as appropriate. If necessary, adjacent Amica appliances sho-

uld be braced with a bracket xed by screws and tted in furniture (Fig. 11). There is a special strip

at the top of the appliance. Attach it to the underside of the cabinet with appropriate screws supplied

with the assembly kit (Fig. 16). Decorative strip must not block the vents located in the bottom casing

unit, the strip must be cut to size (Fig. 17). The depth of the bottom casing unit can be adjusted by

moving it forwards or backwards. Once properly adjusted, tighten the mounting screws (located in

the openings on both sides of the casing unit) with a cross-head screwdriver. This will permanently

attach the casing unit (Fig. 18).

FITTING FURNITURE BOARD TO APPLIANCE DOOR

Place the mounting bracket on furniture board and position it accordingly (Fig. 12). The distance between

the furniture board and the underside of the worktop should be 5 mm (Fig. 13). Attach the mounting

bracket using suitable screws supplied in the installation kit. Pull out the mounting bracket cover and

screw in the two special screws (2) in the appliance doors(Fig. 14). Attach furniture board with the xed

mounting bracket to the appliance door. Secure the furniture board with suitable nuts (item 3, Figure

14). Make sure the furniture board assembly is positioned correctly relative to the appliance (Fig. 15).

Using the supplied screws, attach the furniture board assembly to the bottom of the appliance door

(Fig. 15). Replace the mounting bracket cover in its original location.

1. Unplug the appliance before reversing the door opening direction.

2. Remove food from the appliance.

3. Remove caps on the front of the refrigerator body (Fig. 1, Fig 2).

4. Remove the two screws, which attach the upper hinge to the appliance door (Fig. 3). Take spe-

cial care and hold the appliance door vertically.

5. Holding the door, swing the upper door hinge away from the door using the other hand (Fig. 4).

Beespeciallycarefulduringthisstep,asthehingemaycloseandcauseinjury.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Amica UKS 16158 Seite 76

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info