Bedienungsanleitung Amica ZWM426W (Seite 17 von 25) (Englisch)

794713

Zoom out

Zoom in

Vorherige Seite

1/25

Nächste Seite

A forgotten dish can be added at any time before the detergent cup opens.

Open the door a little to stop the washing.

After the spray arms stop working, you can open the door

completely.

Load the forgotten dishes.

Close the door, the dishwasher will start running again

after 10 seconds.

It is dangerous to open the door when washing,because the hot water may scaldyou.

When the working cycle has finished, the buzzer of the dishwasher will sound for 8 seconds, then stop. Turn off

the appliance using the ON/OFF button, shut off the water supply and open the door of the dishwasher.

Wait for a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while they

are still hot and more susceptible to breakage. They will also dry better.

TurningontheAppliance

1 Draw out the lower and upper basket, load the dishes and push them back.

It is commended That loading the lower basket first, than the upper one (see the section entitled

Loading the Dishwasher ).

2 Pour in the detergent (see the section entitled Salt, Detergent and Rinse Aid ).

3 Insert the plug into the socket. The power supply is 220-240 VAC /50 HZ, the specification of the

socket is 10 A 250 VAC. Make sure that the water supply is turned on to full pressure.

“”

”

4 Close the door, press the ON/OFF button, and the ON/OFF light will turn on.

Press the Program Button to select a desired Wash cycle, the machine will work after 3 seconds.

Starting a cycle wash

NOTE:

If you open the door when washing, the machine will pause. The program light will stop blinking

and the buzzer will mooing every minute unless you close the door. After you close the door , the

machine will keep on working after 10 seconds.

ll of the program lights cut of f

)some of the program lights fast blinking -->error

The program lights shows the state of the dishwasher:

a) A --> stand by

b) One of the program lights on and the door keep open --> pause

c) One of the program lights blinking slowly --> run

If some of the program lights begin to fast blinking after a warning sound

(page 21th "ERROR CODES"), that indicates the machine is out of order, please

turn off the main power and water supply before calling a service.

NOTE:

PREMISE:

Otherwise, the detergent may have already been released,

and the appliance may have already drained the wash water. If this is the case,

the detergent dispenser must be refilled (see the section entitled " Loading the

Detergent " ).

There are two ways of changing the programme :

1. Press the button of running prog. more than 3 seconds to cancel it, then push the button of desired prog.

and it will run after 10 seconds.(see the section entitled " Starting a wash cycle...").

2. Press Button of desired prog. (except buttom of running pro.) more than 3 seconds to change

the running prog. into the prog. which you press, it will run after 10 seconds.

You can modified the washing program, just the dishwasher has been

running for a short time.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Amica ZWM426W Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info