23
The following things should be checked before starting the dishwasher.
The content of this manual is very helpful to the users.
After installation, please make sure to keep this manual.
1
The dishwasher is level and fixed properly
2
The inlet valve is open
3
There is a leakage at the connections of the conducts
4
The wires are tightly connected
5
The power is switched on
6
The inlet and drain hoses are knotted
7
All packing materials and printings should be taken out from the dishwasher
Syphon Connection
Extension Hose
If you need a drain hose extension, make sure to use a similar drain hose.
It must be no longer than 4 metres; otherwise the cleaning effect of the dishwasher could be reduced.
Water Outlet
Connect the water drain hose. The drain hose mu st be correctly fitted to avoid water leaks.
Ensure that the water dra in hose is not kin ked or squashed.
Positioning the Appliance
If the sink is 1000 higher from the floor, the excess water in hoses cann ot be drained directly
into the sink. It will be necessary to drain excess water from hoses into a bowl o r suitable
container that is held outside and lower than the sink.
Position the appliance in the desired location. The back should rest against the wall behind it, and the sides,
along the adj acent cabinets or wa lls. The dishwasher is equipped with water supply and drain hoses that can
be positioned either to the righ t or the left s ides to facilitate proper installation.
How to Drain Excess Water From Hoses
The waste connection must be at a height of between 40 cm (minimum) and 100 cm (ma ximum)
from the bottom of the dish. The water drain ho se should be fixed by a hose clip. The free end of
the hose must not be immersed in water.
Please close the hydrant after using.
Turn off the water.
Release the water pressure by depressing the pressure release button. This relieves water pressure and protects you, and
the room, from severe splashing.
Unscrew The safety supply hose from the faucet..
Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure that it is fastened tightly in place.
If the water pipes are new or have not been used for an extended period of time, let the water run to make sure that the
water is clear and free of impurities. If this precaution is not taken, there is a risk that the water inlet can get blocked and
damage the appliance.
A hose that attaches to a sink spray can burst if it is installed on the same water line as the dishwasher. If your sink has one, it
is recommended thet the hose be disconnected and the hole plugged.
The safety supply hose consists of the double walls. The hose's system guarantees its intervention by blocking the flow of water
in case of the supply hose breaking and when the air space between the supply hose itself and the outer corrugated hose is full
of water.
