Bedienungsanleitung Angelcare AC201-2P (Seite 7 von 56) (Englisch, Französisch, Spanisch)

681983

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

7) Do NOT attempt to recharge batteries provided

with or identified for use with this product that are not

intended to be charged. The batteries may leak cor-

rosive electrolyte or explode.

8) Do NOT attempt to rejuvenate the batteries with or

identified for use with this product by heating them.

Sudden release of battery electrolyte may occur,

causing burns or irritation to eyes or skin.

9) If and when necessary, the batteries must be

replaced with identical new ones or equivalent (volts

and size). If a battery to be replaced is connected

with other batteries in series, replace the other bat-

teries at the same time as well. Do NOT mix old and

new batteries.

10) Reverse polarity installation of the batteries in

the end product must be avoided. Reverse insertion

of batteries can cause charging, and that may result

in leakage or explosion.

11) Remove batteries from this product if you store

the product over 30 days because the batteries could

leak and damage the product.

12) Discard ‘dead’ batteries as soon as possible

since ‘dead’ batteries are more likely to leak in a

product. If a battery has leaked or vented, it should

be replaced immediately using protective gloves.

13) Do NOT store this product, or the batteries pro-

vided with or identified for use with this product, in

high-temperature areas. Batteries that are stored in

a freezer or refrigerator for the purpose of extending

shelf life should be protected from condensation dur-

ing storage and defrosting. Batteries should be stabi-

lized at room temperature prior to use after cold stor-

age.

COMPLIANCE INFORMATION

WARNING

Modifications not authorized by the

manufacturer may void users authority to

operate this device.

NOTE: This equipment has been tested and found to

comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits

are designed to provide reasonable protection

against harmful interference in a residential installa-

tion. This equipment generates, uses and can radi-

ate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause

harmful interference to radio communications.

However, there is no guarantee that interference will

not occur in a particular installation. If this equipment

does cause harmful interference to radio or television

reception, which can be determined by turning the

equipment off and on, the user is encouraged to try

to correct the interference by one or more of the fol-

lowing measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment

and receiver.

• Connect the equipment into an outlet on a circuit

different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV

technician for help.

This device complies with part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1) This device may not cause harmful interference,

and

(2) This device must accept any interference

received, including interference that may cause

undesired operation.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Angelcare AC201-2P Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info