471451
40
Zoom out
Zoom in
Vorherige Seite
1/46
Nächste Seite
38-EN
ALPINE DHA-S690 68-09359Z17-A (EN)
Installation
CAUTION
Be careful that the vehicle’s cords do not touch
the DHA-S690.
If the cords are in contact with the DHA-S690,
their sheaths may be damaged due to vibrations
generated while the vehicle is running, resulting
in short-circuits. Leave enough space when
routing wires to prevent contact between the
vehicle’s wires and the DHA-S690.
To prevent external noise from entering the audio system.
Locate the unit and route the leads at least 10 cm away from the
car harness.
•Keep the battery power leads as far away from other leads as
possible.
Connect the ground lead securely to a bare metal spot (remove any
paint, dirt or grease if necessary) of the car chassis.
If you add an optional noise suppressor, connect it as far away
from the unit as possible. Your Alpine dealer carries various noise
suppressors. Contact them for further information.
•Your Alpine dealer knows best about noise prevention measures so
consult your dealer for further information.
Remove the shipping keys.
Three keys are mounted to the DHA-S690’s bottom panel
to protect the product during transportation. Be sure to
remove these keys before installing the DHA-S690. So as
not to lose the keys, store them in the special plastic
pouch provided with the DHA-S690 and cover the key
holes with the included dust-prevention seals.
•The eject operation cannot be performed if the keys are mounted
when the power is turned on. Turn the power off, then remove the
keys.
1
Mounting strap
Protective plastic bag
for shipping keys
Lock Keys
Install the L-shaped bracket.
1 Determine the position and angle of installation.
2 Referring to step 3, change the position of the springs
according to the angle of installation.
3 Install the L-shaped bracket 2 according to the angle of
installation. Fasten it in place using the double washer
screws (M4x8) 6.
L Example of Installation Using Attached L-
shaped bracket.
6
5
3
4
2
1
6
5
3
4
2
1
L-shaped
bracket holes
H
V
90°
H
V
90°
Vertical
Horizontal
Use any pair of holes
5 or 6 and fix with
4 screws (2 screws ×
both sides).
Use any pair of holes
1, 5 or 6 and fix
with 4 screws
(2 screws × both sides).
Change the position of the springs.
With this product, the positions of the built-in anti-vibration
springs must be changed according to the angle of
installation. The product will not provide the regular
resistance to vibration if the anti-vibration springs are not
in the correct positions or if the left and right springs are in
different positions.
The anti-vibration springs can be placed at one of five
angles.
The springs are set to the “H” angle upon shipment from
the factory. To change this angle, follow the instructions
given below.
1 Remove the covers provided at both left and right sides of
the unit by pressing claws of the covers in the direction
shown by the arrow.
2 Change the position of the springs
using a finger.
3 Mount the covers at the left and
right sides as they were attached
originally.
Install the unit only at a horizontal or vertical angle. If the unit is
diagonally installed, malfunction may result.
2
3
H
V
R
COVER
40

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Apine DHA-S690 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info