Bedienungsanleitung Arcam AVR400 (Seite 18 von 236) (Deutsch, Englisch, Holländisch, Französisch)

578747

Zoom out

Zoom in

Vorherige Seite

1/236

Nächste Seite

E-16

Connecting an aerial

A suitable FM aerial

must be connected to

the AVR400 before FM

radio can be received.

In strong signal areas,

the wire FM aerial

supplied can be used with

reasonable results.

When installed and

receiving FM radio, check the signal

strength by pressing the front panel or

remote control’s

INFO button until the

signal indicator is displayed.

In weak signal areas, or for optimal

FM radio reception, a roof- or lo-

mounted aerial is advised as this

will give superior reception.

In some areas, cable radio may be available or, in an

apartment building, a distributed aerial system may

be installed. In either of these cases you should have

sockets in your home marked

FM or VHF (do not use

those marked TV); these should be connected to the FM

coaxial connector on the rear of the AVR400.

Connecting an aerial

An AM aerial is required to receive AM/medium wave

radio signals, so a simple loop aerial is supplied with

the AVR400. Follow the assembly instructions in the

diagram below.

Make sure that the aerial is positioned well away from

the AVR400 itself, TVs, computers and other sources

of RF ‘interference’. Rotate the aerial to discover which

position gives the best reception.

DAB

(where tted)

In strong signal areas,

the DAB ‘T’ wire aerial

supplied can be used

with reasonable results.

Mount the aerial as high

up as possible on a wall.

In the UK the

‘T’-elements need to be positioned vertically for

DAB reception since broadcasts are

vertically polarised. In other localities,

check with your Arcam dealer or try

both horizontal and vertical positions

for best reception.

Try each usable wall of the room

to see which gives best reception

and use tacks or adhesive tape

to secure the aerial in a ‘T’

shape, but note that no tacks

should come into contact with the

internal wire of the aerial.

When installed and receiving DAB,

check the signal strength by pressing

the front panel or remote control’s

INFO button until the signal quality

indicator is displayed.

In weak signal areas, a high-gain, externally-

mounted or roof-mounted aerial is desirable in

order to receive the highest number of services.

In Band III transmission areas (such as the UK),

use a multi-element Yagi aerial with the elements

mounted vertically, as the transmissions are

vertically polarised. If you are close to more

than one transmitter, use an omnidirectional or

folded dipole aerial.

If the DAB services in your area are transmitted

on L-band, then ask your dealer for advice for

the best aerial to use.

radio

connectors

230V115V

Aerial connectors

e AVR400 is tted with an AM/FM receiver module

and a DAB receiver, depending on the region where it

was sold. e type of aerial you need depends on your

listening preferences and the local conditions.

Your AVR400 is capable of superb radio reception, but

only if it is receiving a good quality transmission signal.

Try the aerials supplied with your unit. If you are in a

medium to strong signal area, these should be adequate

for good reception. In areas with poor signal strength,

you may require a roof or lo mounted aerial.

Contact your local Arcam dealer or aerial installation

experts for advice about local reception conditions.

230V115V

2. Push the tab into the open slot in the

base of the stand. Press until the tab

clicks home.

3. Connect the lead wires to the AM socket

at the rear of the AVR400 (the wires are

not polarised). Rotate the aerial’s stand

until you obtain the best reception.

1. Release the tie-wrap and unwind the

twisted lead. Fold the plastic stand

forward through the loop frame.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Arcam AVR400 Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info