Bedienungsanleitung Arcam DiVA P85-3 (Seite 6 von 14) (Deutsch, Englisch, Französisch)

578761

Zoom out

Zoom in

Vorherige Seite

1/14

Nächste Seite

A85/P85

Using your A85 integrated ampliﬁ er

Front panel controls

This section describes how to operate your ampliﬁ er.

If your ampliﬁ er has not been installed for you, you should ﬁ rst

read the section ‘Installation: A85’ on page 4.

POWER (and power indicator light)

Switches the unit on and off. (You can also switch the ampliﬁ er

into standby mode with the remote control handset.)

The light indicates the status of the ampliﬁ er. A red light means

the ampliﬁ er is in standby mode (press the

Power/Standby

button on the remote control, or the POWER button on the front

panel, to switch between standby and powered-up modes).

When you switch your ampliﬁ er on, the light glows amber

for a few seconds, during which time the speakers are

disconnected. The light changes to green when the ampliﬁ er

is ready for use.

The light may ﬂ ash if a fault has occurred – the fault type is

shown on the display. You should unplug the ampliﬁ er and leave

it for a few minutes before reconnecting. If the fault cannot be

cleared, unplug your ampliﬁ er and contact your Arcam dealer.

Source selectors

These buttons select the source connected to the

corresponding input. A light above the relevant button indicates

which input is currently selected and it will also usually be

shown on the display.

VCR

This input is similar to the other line level inputs on the ampliﬁ er

and may be used with a VCR or a second recording unit (e.g.

cassette deck).

TONE

Switches the tone circuits on and off, including settings for

individual sources. Note that the tone LED does not light unless

a tone setting has been made. (see page 8).

Control knob, SELECT and ENTER

3bobn

The control knob has two functions:

■ as a volume control, to adjust the output of loudspeakers

and headphones connected to the ampliﬁ er, and of the

pre-amp output (PRE OUT).

■ when used in conjunction with the SELECT and ENTER

buttons, to customise ampliﬁ er settings (see page 8).

Volume control settings

It is important to realise that the position of the volume

control is not an accurate indication of the power delivered to

your loudspeakers. The ampliﬁ er often delivers its full power

long before the volume control reaches its maximum position,

particularly when listening to heavily recorded compact discs.

However the ampliﬁ er also has to be capable of giving full

power output from much lower level sources, such as tuners

and cassette decks. Using these sources, the volume control

setting may be much higher before distortion (audible overload)

sets in. To compensate for this, the input levels of each source

may be individually adjusted to avoid accidental overload (see

page 8).

SP1 and SP2

These buttons allow you to select and deselect the main (SP1)

and secondary (SP2) set of speakers attached to your ampliﬁ er.

The light above each button glows if the corresponding

speakers are currently selected. If both lights are out the

ampliﬁ er will appear not to work, as all speakers are switched

off! If both are on, with two pairs of low impedance speakers

connected, overloads are more likely. Overloading the ampliﬁ er

may cause it to shut down because of overheating.

PHONES

This socket accepts headphones with an impedance rating

between 8Ω and 2kΩ, ﬁ tted with a 1/4-inch stereo jack plug.

If you wish to listen on headphones only, use the SP1 and SP2

buttons (if necessary) to mute the speakers. The headphone

socket is always active.

Remote control receiver

The remote control’s infrared receiver is positioned to the left

of the

RECORD button. Ensure the receiver is in a clear line of

sight from the remote control to allow signals to be received.

MODE, UP and DOWN

blbm

These buttons are mainly for use with future optional modules,

however the UP and DOWN buttons are used with the basic A85

ampliﬁ er to move the cursor when customising the ‘Welcome

message’ (see page 8).

321678

9bk

A85 INTEGRATED AMPLIFIER

PHONO/AUX CD TUNER AV DVD VCR TAPE TONE SP1 SP2 POWERPHONES

RECORD MODE

ENTER

SELECT

bl bm bnbo

A85/P85 multi.id 03/29/01, 3:35 PM6

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Arcam DiVA P85-3 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info