Bedienungsanleitung Arcam DiVA T51 (Seite 5 von 8) (Deutsch, Englisch, Französisch)

578785

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

T51

Using your tuner

Front panel controls

Preset memory buttons

You can store up to a total of 24 radio stations as presets.

There are two storage ‘levels’:

FM ‘level’ where 16 stations can be stored.

AM ‘level’ where 8 stations can be stored.

The 8 stations can be either AM, LW or a combination of the

two. Your ﬁ rst and ninth FM stations are stored using button

1–9; your second and tenth FM stations are stored using button

2–10 and so on.

BAND

Selects FM, AM or LW frequency band. The appropriate letters

appear on the display.

MONO

Selects mono or stereo output. Stereo is only available on FM

radio stations.

The word ‘MONO’ or ‘STEREO’ lights on the display.

If a weak station is received in stereo the background hiss

can be reduced (and in most cases eliminated) by selecting

‘MONO’.

AUTO

When pressed, the word ‘AUTO’ illuminates in the display. When

either of the tune buttons

are pressed,

the tuner stops

automatically at a station with any suitably strong signal.

To continue searching, press either of the tune buttons again .

STORE

The STORE button allows you to assign radio stations to preset

numbers (1–16 for FM and 1–8 for AM). See the instruction ‘To

store a radio station in memory’.

Tune down/up

Press to tune up or down through the chosen frequency band.

When pressed and held, the tuner scrolls continuously, when

touched and released, the tuner scrolls in ﬁ xed amounts.

TUNE indicator

This glows green when you are correctly tuned to a signal on

any band. When the tuner is not tuned to a signal of sufﬁ cient

strength, the indicator is off.

Frequency display

Indicates the frequency of the selected station in MHz (FM) or

kHz (AM).

Preset indicator

Indicates the number of the preset currently selected.

POWER

Switches the unit on and off.

Power indicator

This glows green to show that the unit is switched on.

To store a radio station in memory

Select the waveband (FM, AM or LW) using BAND and tune

into the radio station you wish to store.

Press the

STORE button.

You will see a small ﬁ gure ‘1’ in the display at

Within ﬁ ve seconds, press the memory button (numbers 1 to 8)

you wish to store the station under.

The station is stored when a number appears in the right hand

end of the display at

To store stations 9–16 in FM, proceed as above but press the

STORE button twice.

You will see a small ﬁ gure ‘2’ in the display at

This will access the presets

9–16.

To select a stored radio station

Select the waveband (FM, AM or LW) using BAND and tune.

To select stations stored on presets 1 to 8, press the memory

button number which stores the station you wish to select, for

less than one second only.

To select stations 9 to 16 in FM, proceed as above, but press

the memory button number which stores the station you wish to

select, and hold for one second.

NOTE: The preset memory will be retained while the tuner is

connected to the mains. If the mains supply is disconnected,

the memory will be retained for approximately one week.

POWER

T51 AM/FM TUNER

STOREAUTOMONOBAND TUNE

432

576

bkbl

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Arcam DiVA T51 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info