NOTE
Remember to correctly install the two AA batteries
supplied before trying to use your remote control.
The CR80 remote control is a multi-function unit that controls the AV9
and up to seven other devices. The instructions on this page only refer
to the control of the Arcam FMJ AV9.
For information on using the remote control for other devices, and a
full list of features, see the instruction booklet supplied with the CR80.
TRM (Speaker trim)
Press to display the OSD Speaker trim level
menu. TRM allows temporary adjustment of
speaker levels, using the navigation buttons.
Press again to exit the ‘Speaker Trim’
function.
Source selection
DVD – DVD input
SAT – Satellite input
VCR – Video Cassette Recorder input
CD – Compact Disc player input
AUX – Auxillary (line) input
TAPE – Tape (monitor) input
TUN – Tuner input
AV – AV input
MCH – DVD-A (multichannel) input
Press the relevant button once to select
input; press and hold to select the analogue
input if a digital input is present.
Device selection
IMPORTANT: Press the AMP button rst to
operate the AV9.
On/Standby
This allows the AV9 to be put into and taken
out of standby remotely.
Navigation buttons
Arrow buttons allow navigation around the
menus on the AV9.
Conrm selection by pressing OK. Press and
hold the OK button to swap PAL/NTSC OSD
modes.
MENU
Press to select the OSD Main menu.
Press and hold for more than two seconds to
select the ‘Setup Menu Index’.
FAV (Favourite)
Use this button to clear any temporary
adjustments and return to the current
preset settings.
SUB (Subwoofer trim)
Allows a temporary trim of the subwoofer
level. Press SUB, then adjust using
the
34
buttons on the navigation panel.
THX (THX mode)
Use this button to cycle through available
THX modes.
FX (DSP effects mode)
Use this button to cycle through effects
modes for two-channel sources.
The other buttons in this area are used for
DVD and Tuner control and do not effect the
AV9.
SYN (Lip sync)
Press once to adjust the Lip sync audio
delay. Use the
3
and
4
navigation buttons.
Press again to exit the Lip sync function.
MUTE
Press once to mute the main system. Press
again (or use VOL +/–) to un-mute.
MODE
Use this button to cycle through available
surround modes.
INFO
Press once to display the OSD report on
source inputs and processing mode.
DIS (Display)
Press to cycle through Off/Dim/Bright
illumination of the front panel display
VOLUME +/–
Adjusts the volume.
