Bedienungsanleitung Arcam fmj ms250 (Seite 9 von 36) (Englisch)

159827

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

MS250

POWER

Press this button to switch on the MS250. The power indicator light changes from red

to green. From power-on, the MS250 will take about 30 seconds to initialise; a start-up

message is displayed on the front panel.

When powered-on, press this button for a second time to switch the unit off. The

MS250 takes a few seconds to shut down. To avoid risk of data loss, do not remove

power from the unit during this period.

LOAD

To load a CD, press LOAD (or OPEN on the remote control). The CD tray opens to accept 12cm or 8cm

discs. Place the CD in the tray with the label facing uppermost. Press

LOAD again (or press PLAY, or

gently push the tray in 5mm) to close the tray. After a few seconds, if the CD has been found in the

online database, the track names appear on the display.

Music control keys

These keys can be used to control CDs and stored music.

Play/Pause: Press

;

to play the current music selection. Press again to pause the music. If the

music is paused, pressing

;

again will resume the music from the point where it was paused.

Stop: Press

< to stop the current music selection. Pressing

;

after the music has been stopped will

resume playing at the start of the current track.

Search forwards/backwards: Press

on the front-panel or remote control to search fast

forward or backwards. The following speeds for fast search are available: x2, x4, x8, x16 and x32. Press

the button repeatedly to cycle through the different speeds. To resume normal playback speed (and play

the CD or stored music), press

;

Skip track: To start a CD with a track other than the rst, press

/ or 0 to locate the desired track.

To select another track at any time during play, press

/ or 0.

Menu navigation keys

These keys allow navigation through the MS250 menu system – they match the cursor keys on the

remote control. Use the up-down-left-right keys to move the menu highlight to the item of interest, then

press

OK to open or select the highlighted item. The HOME key returns you to the top-level menu.

DISPLAY

This key changes the brightness of the display. Press repeatedly to reduce the brightness in steps from

full brightness to off. Press once more to restore to full brightness.

ZONE

Press the Zone button to select the zone you wish to view or control. There are four output zones, which

in a typical installation will be routed to different rooms in the house. The zone number is shown on the

display along with the audio settings for that zone. You can route different audio sources to different

zones. For example, you can play a stored CD in one zone and Internet radio in another zone at the

same time.

USB connector

The front panel USB connector is in addition to the two USB connectors on the back panel of the MS250.

It allows easier access to the MS250 for playing music or transferring music les from portable music

sources. You can also attach a USB keyboard here to make text editing easier.



POWER

LOAD

OKHOME ZONE

DISPLAY





Front-panel controls

NOTE

To put the unit into stand-by, press

the power button on the remote

control or front panel. The front

panel display dims and shows the

time and date.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Arcam fmj ms250 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info