Bedienungsanleitung Arcam P1 (Seite 7 von 16) (Englisch)

578752

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

C31/P38/P1

E-6

English

C31/P38/P1

E-7

Recording an audio source

The C31 allows listening to and recording from the same source, or listening to one source whilst

recording another. The signal to be recorded is sent to both the TAPE and VCR output sockets.

Selecting the source for recording

The recording outputs can be congured in two ways:

1. to allow recording of the source being listened to;

2. to allow recording of a particular (specied) source, regardless of what is being listened to.

To record the source being listened to, press the RECORD button

repeatedly until the display

shows ‘Record source’. After a few seconds the display reverts to showing the volume level, and you are

ready to record.

In this conguration, selecting a different input changes the source that is routed to the recording

outputs.

To record one source whilst listening to another, press RECORD again until the display shows

‘Record’ followed by the name of an input (e.g., ‘Aux’, ‘CD’, ‘Tuner’, etc.). Now press the source-selector

button on the front-panel for the source you wish to record. Your selection is shown on the display for a

few seconds, after which the display reverts to showing the volume level. You are now ready to record.

Pressing a different source-selection button changes the source that you are listening to, but does not

alter the source that is routed to the recording outputs.

Tape-to-tape copying (dubbing)

You can perform tape dubbing from VCR to TAPE, but not from TAPE to VCR.

For example, to copy from a cassette recorder connected to the VCR socket to a cassette recorder

connected to the TAPE socket, rst use the RECORD button as explained above and select ‘Record VCR’.

This routes the VCR signal to the TAPE output.

Listening using headphones

The headphone socket

accepts headphones with an impedance rating between 8Ω and 2kΩ,

tted with a 6.5mm stereo jack plug. The pre-amp. outputs are muted when headphones are

plugged in.

The headphone socket is always active, unless the volume has been muted.

Product conguration

The C31 has a conguration menu that allows various performance and behaviour aspects to be

altered. This menu is described in detail on the next page. Buttons have been provided on the

front-panel to allow direct access to the most important conguration menu items:

BALANCE - gives direct access to the “Balance” menu item.

DISPLAY - this changes the display brightness. There are three brightness levels to chose

from: ‘on’, ‘dimmed’ and ‘off’. If the C31 is switched off while the display is set to ‘off’, the display

will be set to ‘dimmed’ when the C31 is switched on again.

REF - this toggles the volume display mode between ‘Standard’, ‘Fine’, and ‘Reference’ (these are

described on the next page. When the ‘Reference’ volume display is selected, the light above the

Ref button is illuminated.

TRIM - gives direct access to the “Trim” menu item.

Did you know: the

original 6.5mm (or

1/4”) head-phone jack,

dates from 1878 for use

in manual telephone

exchanges – making

it possibly the oldest

electrical connector

standard on earth.

Source: en.wikipedia.org

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Arcam P1 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Arcam P1

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info