Bedienungsanleitung Arcam solo mini (Seite 6 von 18) (Englisch)

160363

Zoom out

Zoom in

Vorherige Seite

1/18

Nächste Seite

Connecting a record deck

Solo Mini is not tted with a phono

pre-amplier. If you wish to connect

a record deck to Solo Mini, then

you’ll need an external pre-amplier.

Please contact your dealer for further

information and recommendations on

the best option for you.

Controlling an iPod

Music or podcasts from your iPod can

be fully integrated with your system

using Arcam’s rDock or rLead. These

accessory units use the RS232 CONTROL

and IPOD/TAPE connectors to take over

the control and amplication, with

iPod text appearing on the front panel

display of Solo Mini.

Information on connecting and using

an iPod with the Solo remote is given

in the rDock or rLead quick start

guide supplied with these accessory

units, but see ‘iPod connection’ in the

connectivity section of this manual.

rear panel

IN OUT

REMOTE

OUT

PROG

SPEAKER

OUTPUT

OFF/ON

RIGHT LEFT

AMFMDAB

RS232 CONTROL

GAME AV iPod/TAPE TV TAPE PRE OUT

–

220-240V

50–60Hz

250W MAX

O I

Remote output

This output carries all signals from the

front-panel remote-control receiver. This

can be used to route remote-control

commands to other equipment (potentially

in different locations). For example,

amplier commands could be received by

Solo Mini, then routed to a power amplier

in a remote location using this output

connector.

Programmer switch

This is an override switch that allows an

Arcam dealer to install software upgrades.

The user should not access this facility.

Tape output

This is the output to be used

for connecting to an audio

recorder or for a second room

system. It should be connected

by Phono–Phono (RCA)

cables to the amplier in the

second room.

Preamp output

If you require more power than Solo Mini’s 25W per

channel, you can connect an external power amplier.

Connect the

PRE OUT sockets to the input sockets of

your power amplier, then connect your speakers to

the power amplier’s speaker terminals.

This output may also be used to provide a signal for

a self-powered Low Frequency Effects speaker (a

subwoofer). Arcam’s Logo speaker ideally matches

the design and output characteristics of Solo Mini.

Analogue inputs

Solo Mini provides four pairs of analogue

inputs, allowing connection of other stereo

sources (e.g. a games console, AV, iPod/

Tape, or TV). All four inputs have the same

characteristics – the labels below the inputs

give suggested uses.

To connect a device to an input on the

rear of Solo Mini, use a stereo phono cable

of a suitable length. We advise you to use

high-quality interconnect cables wherever

poss ble to ensure the best poss ble sound

quality.

Antennae inputs

These inputs can be used with the aerials

provided (DAB, if tted, has a telescopic

aerial, FM a wire aerial, and AM a loop

aerial). In weak signal areas, external aerials

of the correct type may be required for

optimal reception.

Speaker outputs

Connect your Muso speakers

here!

Mains power input

100V, 115V or 230V AC,

depending on shipping region

Mains switch

This is the main Off/On

switch, though it is usual to

place the unit in low-power

‘Standby mode’ when not

in use.

RS232 control

This is used for controlling an iPod (see page 9),

or for control via a remote computer.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Arcam solo mini Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Arcam solo mini

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info