E13
English
technical
specication
Pre-amplier
Inputs
Maximum input level 2.5Vrms
Input impedance
47kΩ
Signal/noise ratio 105dB
Co-axial outputs
Maximum output level 2.5Vrms
Output impedance
500Ω
Optical output (TOSLINK)
Sample rate 44.1kHz (with CD playback),
48kHz (with DAB receiver),
otherwise muted.
Amplier
Continuous power output, per channel, 80kHz measurement bandwidth
Both channels, 4Ω, 1kHz
75Wrms, 0.013% THD+n
Distortion, both channels 4Ω, 80% power, 1kHz
0.011% THD+n
CD play-back
DAC Wolfson 24-bit multilevel Delta-Sigma DAC
Frequency response (±0.5dB) 20Hz–20kHz
DAB receiver (where tted)
DAC AKM 96kHz 24-bit Delta-Sigma DAC
RF tuning range 174–240MHz (Band III)
1452–1490MHz (L-band)
Sensitivity (typical) –98dBm (VHF measurement to EN50248)
Input impedance
50Ω
Audio data rate (maximum)
224kbits/s MPEG layer II, protection level 3
Number stored services (maximum) 128
FM receiver
RF tuning range 87.5–108MHz
Sensitivity (typical) 2µV
Signal/noise ratio (at 200mV) 58dB
Distortion (THD at 200mV) 0.5%
AM receiver (where tted)
RF tuning range 522–1611kHz
Signal/noise ratio (at 200mV) 40dB
Distortion (THD at 30% modulation) 1.5%
General
Supply voltage 100V, 115V or 230V AC,
depending on shipping region
Power consumption
Stand-by 3.2W;
Operational 50W (typical), 400W (maximum)
Size (W x D x H) W430mm x D350mm x H79mm
Weight (net) 7.75kg
Weight (packed) 10.5kg
Supplied accessories Mains lead
Wire dipole aerial (Band III)
Remote control handset and two AAA batteries
Instruction manual and registration card
Radio interference
Solo is an audio device containing microprocessors and other digital electronics. It has been designed to
very high standards of electromagnetic compatibility.
If Solo causes interference to radio or television reception (which can be determined by switching Solo
off and on), the following measures should be taken:
n Re-orient the receiving antenna or route the antenna cable of the effected receiver as far as
possible from Solo and its cabling.
n Relocate the receiver with respect to Solo.
n Connect the receiver and Solo to different mains outlets.
If the problem persists, please contact your Arcam dealer.
