Bedienungsanleitung Arcam SoloBar (Seite 14 von 115) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch)

578739

Zoom out

Zoom in

Vorherige Seite

1/115

Nächste Seite

E-23E-22

English

Continual improvement policy

Arcam has a policy of continual

improvement for its products. is

means that designs and specications

are subject to change without notice.

specications

General

Weight (Packed) 10kg

Dimensions (H x W x D) 130mm x 1100mm x 110mm

Power consumption Operating mode: 150W (max)

Standby mode: <0.5W

Power requirements 100 – 240V, 50/60Hz

Inputs/Outputs

HDMI In Type A receptacle x 4

HDMI Out Type A receptacle, with ARC/CEC support

Digital In (Optical) S/PDIF Optical receptacle

Digital In (Coaxial) RCA jack

Auxiliary In 3.5mm stereo jack

Bluetooth Audio Ver. 3.0, Compliant with A2DP standard

Subwoofer Out RCA LFE jack

Wireless Subwoofer Output

Frequency 2.4GHz

Transmission range Approx. 20m (without interference)

Amplifier

Rated power output:

Woofer (0.5% THD)

Tweeter (0.5% THD)

40W per channel

10W per channel

Nominal Amplifier Output Level (20Hz-20kHz) 100 W

Speakers

Woofer 1 2 x 4in Cone

Woofer 2 2 x 4in Cone

Tweeter 2 x 1in Cone

Woofer frequency response 170Hz – 20kHz ± 3dB

Tweeter frequency response 3.8kHz – 14kHz ± 3dB

Rated impedance 6Ω

E&OE

NOTE: All specification values are typical unless otherwise stated.

troubleshooting

Here are some simple checks you can do if

you are experiencing problems with your

Solo bar.

Power

< Check that the power cord is plugged in

and connected properly.

< Make sure the power and mains

switches are turned on.

Remote control

< Check the batteries are inserted

correctly.

< Batteries may need replacing.

< Are you too far away from the unit or is

there an obstruction?

Sound

< Make sure the cables are connected

properly.

< Check that the right input source is

selected.

< If the sound is noisy or distorted during

playback from a Bluetooth device, try

turning the volume down on the device

and up on the Solo bar.

Picture

< If there is no picture or it is displaying

badly, check the HDMI cables are

connected properly.

< Check that the right input source is

selected.

Bluetooth

< Check your Bluetooth device is paired

correctly.

< Is your Bluetooth device too far away

from the unit?

FCC Notice

is product contains FCC ID: VNH-IK-

CSRBC05/QEC-GWNO

is equiment has been tested and found to

comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC

Rules. ese limits are designed to provide

reasonable protection against harmful

inteference in a residential installation.

is equipment generates, uses and can

radiate radio energy and, if not installed and

used in accordance with the instructions,

may cause harmful interference to radio

communications. However, there is no

guarantee that interference will not occur in

a praticular installation. If this equipment

does cause harmful interference to radio

or television reception, which can be

determined by turning the equipment o

and on, the user is encouraged to correct the

interference by one or more of the following

measures:

< Reorient or relocate the receiveng

antenna.

< Increase the separation between the

equipment and the receiver.

< Connect the equipment to an outlet on

a circuit dierent from that to which

the reciver is connected.

< Consult the dealer or an experienced

radio/TV technician for help.

is device complies with part 15 of the

FCC Rules. Operation is subject to the

following two conditions:

(a) is device may not cause harmful

interference, and

(b) is device must accept any interference

recieved, including interference that may

cause undesired operation.

(FCC Part 15.21) Caution: changes or

modications not expressly approved by

the party responsible for compliance could

void the user’s authority to operate the

equipment.

Canada ICES-003 statement

is product contains IC

10581A-IKCSRBC05/10581A-GWK5NO

is product complies with RSS-210 of

industry Canada.

Operation is subject to the following two

conditions:

(1) this product may not cause harmful

interence, and (2) this product must

accpet any inteference received, including

interference that may cause undesired

operation.

is Class B digital apparatus complies with

Canadia ICES-003.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Arcam SoloBar Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info