Bedienungsanleitung Arctic Spas Frontier (Seite 83 von 124) (Englisch)

765005

Zoom out

Zoom in

Vorherige Seite

1/124

Nächste Seite

Step 2. Test and Adjust pH (Use drop Test Kit)

Test pH. Levels should be between 7.2 – 7.6. If pH is high, (over 7.6) add Arctic Pure, Salt Water Balance.

NOTE: Salt systems naturally drive pH levels to increase, strive to achieve a balanced pH level.

NOTE: High pH will cause calcium to precipitate (fall out of suspension). The problem with calcium falling out of

suspension is that it collects on the heater and pump, and shortens their life.

Step 3. Mix Salt Crystals

Dissolve 1/3 of the required recommended salt dosage in a 5 Gallon (20 litre) pail of hot water.

Refer Arctic Spas – Spa Boy Salt Dosage Chart contained in this guide.

WARNING: Salt causes pH to rise, to help ensure pH can be managed within the target range, it is most impor-

tant not to add the entire salt dose in one step. If all the salt is added in one dose it may increase the pH level to

an unmanageable level that requires the spas water to be drained.

Step 4. Add Salt to Spa Water & Re-Test TA / pH

(a) Slowly pour the dissolved salt from the pail into the spa water.

(b) Run pumps for 5 minutes to help mix salt blend through.

(d) Then re-test and adjust pH level accordingly.

Refer: Steps 2 for correct pH levels.

Step 5. Repeat Steps 3 & 4

Repeat steps 3 and 4, ensuring all sub steps are carried out accordingly.

Step 6. Repeat Steps 3 & 4

Repeat steps 3 and 4, ensuring all sub steps are carried out accordingly.

Step 7. Test Sodium Chloride Level

(Aquacheck Salt Test Strips are suggested) Also refer Sub Steps to Help Ensure Sodium Chloride Test Strips

are Used Correctly. You will now need to test sodium chloride levels. This can be carried out using a salt tests

strip. If sodium chloride levels are low, dissolve 1/2 lb (225 Grams) of salt (using cup provided) into hot water.

Pour the dissolved salt into the spa water. Test sodium chloride level. Repeat until required sodium chloride

level is reached:

Understanding Spa Boy®

NOTE: For start up it is recommended to strive for the minimum salt dosage. Once a Sodium Chloride reading

has been taken and the minimum salt dosage achieved, it can be increased slightly to accommodate spa usage

and bather load.

NOTE: The Arctic Spa Boy Salt Chart in this guide provides the estimated impact of adding ½ lb (225Grams) of

salt to your spa.

Spa Boy Owners Manual

Spa Boy Owners Manual Version 1 Revision 1 (R1)

Page 18 of 35 Issued 20 Nov 2014

Steps to Establish Chemically Balanced Water With Spa Boy

Step 5. Add Salt to Spa Water & Re-Test TA / pH

(a) Slowly pour the dissolved salt from the pail into the spa water.

(b) Run pumps for 5 minutes to help mix salt blend through.

(d) Then re-test and adjust Total Alkalinity level accordingly.

(e) Then re-test and adjust pH level accordingly.

Refer: Steps 2 and 3 for correct TA/pH levels

Step 6. Repeat Steps 4 & 5

Repeat steps 4 and 5, ensuring all sub steps are carried out accordingly.

Step 7. Repeat Step 4 & 5

Repeat steps 5 and 6, ensuring all sub steps are carried out

accordingly.

Step 8. Test Sodium Chloride Level

You will now need to test sodium chloride levels. This can be carried

out using a salt tests strip.

If sodium chloride levels are low, dissolve 1/2 lb (225 Grams) of salt

(using cup provided) into hot water. Pour the dissolved salt into the

spa water. Test sodium chloride level.

Repeat until required sodium chloride level is reached:

Spa Boy Version

Minimum

Maximum

Version 1 R1

2000ppm

2500ppm

Note: The Arctic Spas Spa Boy Salt Chart in this guide provides

the estimated impact of adding ½ lb (225Grams) of salt to

your spa.

Note: Having the correct dosage of salt concentration, will reduce

potential corrosion and increase the life of the Spa Boy

Output Electrode.

Spa Boy Version Minimum Maximum

Version 1 R1 2000ppm 2500ppm

Owners Manual - Spa Boy®

8383

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Arctic Spas Frontier Seite 83

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info