Bedienungsanleitung Arctic Spas Totem (Seite 112 von 124) (Englisch)

765013

112

Zoom out

Zoom in

Vorherige Seite

1/124

Nächste Seite

Onzen Questions

Question 1: How do I know if the Onzen system is working?

Conduct a “Sanitizer Production test” (Also known as a Smoke test).

This procedure activates the Onzen System while de-activating the ltration pump so you can see the

mist of gas bubbles produced by the Onzen System.

Question 2: What should I do if it fails the “Sanitizer Production test”?

First, conrm you have the correct concentration of salt in the water “using sodium chloride test strips”.

Then, start maintaining your water manually using “Boost” granular chlorine to sanitize and Adjust Up /

Arctic Pure Salt Water Balance to balance pH. Continue to do this daily until the system is repaired by an

authorized service technician.

* Keep enjoying your hot tub!

Question 3: What should I do if the chlorine levels are too high?

Turn the Onzen Output down (decrease “On” settings).

Unless you added granular chlorine or shock to the water high chlorine levels mean the system is staying

on too long for your circumstances. It may take a day or two for levels to normalize, or you can speed this

process up by using a chlorine neutralizer, such as “X-it”.

Question 4: What should I do if the pH keeps increasing?

Conrm that your Total Alkalinity is at the recommended level and reduce it manually with Arctic Pure Salt

Water Balance. This is normal; all spa salt systems cause pH to increase.

Question 5: Will the salted water damage my lawn?

This is very unlikely.

The recommended concentration of salt is used is approximately 10% of the concentration of sea water.

Question 6: Why is my water bright yellow, or bright green, or a rusty colour suddenly?

This can happen if the pH gets too high.

Lower the pH using Arctic Pure Salt Water Balance. High pH is a sign that the Onzen Output may be

turned up too high, so you may need to adjust the Onzen Output After balancing the pH and adjusting the

Onzen Output wait about 48 hours. If the colour of the water does not normalize you may need to replace

the water.

* Keep an eye on the pH and adjust it weekly to avoid this problem in the future.

Question 7: What is the typical amount of maintenance I need to do with Onzen?

1. Change the water twice a year.

2. Change the lter 4 times a year.

3. Check the Total Alkalinity weekly to make sure it is in the target range (Under 100).

4. Adjust the pH once a week. Salt systems naturally drive pH levels to increase, strive to achieve a Low

pH level 7.2

must not exceed 7.6.

5. Check Calcium level monthly to ensure it is in the target range. Salt systems perform best with Low

Calcium levels;

strive for a target range between 50 - 150 ppm.

6. Adjust the Onzen Output “On” if hot tub use changes signicantly.

7. Adjust the chlorine levels using “Boost” granular chlorine, after heavy use or if the Onzen Output is too

low. Refer: Onzen Maintenance Schedule for further details.

1.12 Onzen Frequently Asked Questions

112112

Understanding Onzen™

Owners Manual - Onzen™

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Arctic Spas Totem Seite 112

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info