Bedienungsanleitung Argo Daven Plus (Seite 13 von 20) (Englisch)

805075

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

33V 04/23

1. ON/OFF BUTTON

Press this button to switch the unit on or off.

When switched on, the appliance will start functioning based on its last settings (save function).

2. FILTER RESET BUTTON

Every 250 hours this led will light up to and It means the air lter should be cleaned. After clieaning press this

button to reset the running time.

3. FAN SPEED ADJUSTMENT BUTTON

Press this button when the appliance is switched on for adjusting the ventilation speed in cooling mode (AUTO),

to low (Low), medium (Med) or high (High).

The fan speed cannot be adjusted in DRY mode and is xed at low.

4. “+” and “-“ BUTTONS

Press “+” or “-“ to regulate the temperature (the adjustment step is 1 °C) and set the timer (each time the keys are

pressed, the adjustment step is 0.5 hours up to 9 hours, while from 10 to 24 hours the adjustment step is 1 hour).

The temperature ranges from 16 °C to 32 °C, and the time ranges from 0,5h to 24h

5. MODE SELECTION BUTTON

Press this button to select the different operating modes, according to this sequence:

Auto (AUTO) -> Cooling (Cool) -> Dehumidication (Dry) -> Ventilation (Fan) -> Heating (Heat)

In the COOL, DRY and FAN modes the display light up.

6. SLEEP BUTTON

a. In operating mode, press “SLEEP” to enter 10h intelligent sleep mode. After 10 hours, the air conditioner will

exit sleep mode to restore the previous mode.

b. In sleep mode, press “SLEEP” again, or press “MODE” or “ON/OFF” to exit sleep mode.

Note: sleep function is not available in ventilation mode. In Sleep mode there is no variation of the fan speed. In

cold mode, after the rst hour the set temperature increases by 1 °C, after the second hour it increases again by 1

°C; after the 5th hour it decreases by 1 °C, continues like this for another 3 hours and then exits the Sleep function,

continuing to function normally in cold mode. In heat, the reverse happens. After the rst hour the temperature

decreases by 1 °C, after the second hour it decreases again by 1 °C; after the fth hour it increases by 1 °C,

continues like this for another 3 hours then exits the Sleep function and continues to function normally in heating

mode.

7. TIMER BUTTON

a.When the air conditioner is turned off, press “TIMER” to set a time to turn on the air conditioner. Press “+” or “-“

to set the time, and press “TIMER” again to conrm it.

b. When the air conditioner is turned on, press “TIMER” to set a time to turn off the air conditioner. Press “+” or “-“

to set the time, and press “TIMER” again to conrm it.

c. After setting the time, press “TIMER” again to cancel the set time.

8. SWING BUTTON

Press this key to turn on or off the horizontal louver swing.

TEMPERATURE AND ERROR DISPLAY

With the exception of message P1, tank full, when an error occurs do not attempt to repair the air conditioner, always

take it to an Argoclima Assistance Centre, otherwise the guarantee will no longer be valid.

Auto

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Argo Daven Plus Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Argo Daven Plus

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info