Bedienungsanleitung Argo DRY PURY EVO WF 17-21 (Seite 9 von 18) (Englisch)

805014

Zoom out

Zoom in

Vorherige Seite

1/18

Nächste Seite

28V 04/23

Press the Mode button again to deactivate this function.

• Laundry mode: Press the Mode button to activate the Laundry mode, the icon lights up on the control

panel. The unit operates continuously regardless of the humidity level, therefore it is not possible to adjust the

% humidity. Instead, it is possible to adjust the ventilation speed using the FAN button.

3. HUMIDITY BUTTON (HUM)

Press this button to view the % humidity in the room. Press this button again to adjust the desired humidity from

30% to 80% in 5% steps.

After making the adjustment, the set % will ash on the display for 3 seconds, thus conrming the successful setting,

the display will then go back to showing the % humidity in the room.

By holding this button down for 3 seconds, the humidity level in the room is shown on the display.

This button can be used also to set the Timer.

4. TIMER/WIFI BUTTON

Timer Function

Press this button to program switching on (if the unit is off) or switching off (if the unit is on) from 0 to 24 hours.

Press the HUM button to set the desired time, each time it is pressed the adjustment interval corresponds to 1 hour,

and it is possible to view the set time on the display. The LED on the control panel stays on during the set time

interval. To deactivate the Timer, “00” must appear on the display (it ashes 4 times), and the Timer symbol on

the control panel will switch off.

Wi Function

Press and hold this button to start network setup or disconnect WIFI. When the Wi LED ashes on the control

panel it is possible to connect the Wi. If no connection is made within 3 minutes, the LED will stop ashing, and

connection will not be possible. Press and hold this key again to connect Wi.

5. FAN BUTTON

Press this button to adjust the fan speed in the following circular sequence: High - Low:

The corresponding LEDs light up on the control panel according to the selection made.

The fan speed can be adjusted in Laundry and Sleep modes, while when automatic defrosting is in operation it’s

not possible to adjust it.

6. CHILD LOCK BUTTON

Press this button for 3 seconds to activate the control panel lock function, the LED on the control panel lights

up, and it is no longer possible to make selections on the control panel. Press this button again for 3 seconds to

deactivate this function, the LED goes out.

When the appliance is switched off, the child lock function is automatically deactivated.

MEMORY FUNCTION

The dehumidier keeps the last settings selected before switching off or black out.

COLORED LED STRIP

On the side part of the dehumidier there is a LED strip which colors differently according to the level of humidity

detected in the environment:

Blue = Ambient humidity lower than 45%

Green = Ambient humidity between 45% and 65%

Red = Ambient humidity higher than 65%

If the following error codes E0, E1, CL, CH, LO, HI appear on the display on the control panel, the side LED strip

will be red (for error codes, refer to the troubleshooting section).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Argo DRY PURY EVO WF 17-21 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Argo DRY PURY EVO WF 17-21

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info