Bedienungsanleitung Argo Emix Tank (Seite 18 von 30) (Deutsch, Englisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch, Finnisch)

665483

Zoom out

Zoom in

Vorherige Seite

1/30

Nächste Seite

In case of Emix is connected to a normal indoor unit port (for example with G30 or G42) the unit must be disconnected

exactly as any other air indoor unit. On the outdoor unit electrically disconnect the reversing valve to force the system in

cooling.

In case of Emix is connected to the Emix port and by any reason it has to be disconnected and replaced, the installer has

to do this procedure using a refrigerant recovery unit:

- close the valves of Emix port that connect Emix to outdoor unit;

- connect the refrigerant recovery unit to one of the two valves;

- recover the refrigerant inside the copper pipes and Emix unit;

- disconnect Emix;

- reconnect another Emix unit;

- make the vacuum;

- restore the refrigerant from recovery unit to the pipe and Emix unit;

- disconnect the recovery unit;

- re-open the valves of Emix port that connect Emix to outdoor unit.

In case of Emix is connected to the Emix port and by any reason it has to be removed denitively, the installer has to do

this procedure using a refrigerant recovery unit:

- close the valves of Emix port that connect Emix to outdoor unit;

- connect the refrigerant recovery unit to one of the two valves;

- recover the refrigerant inside the copper pipes and Emix unit;

- disconnect Emix;

- reconnect the bypass disconnected during the rst installation;

- disconnect the recovery unit;

- make the vacuum on the bypass;

- re-open the valves of Emix port that connect Emix to outdoor unit;

- switch on the outdoor unit in cooling mode;

- recover the refrigerant inside the system connecting the recovery unit to one of the liquid valve of indoor units or to the

pressure valve of the inlet tube;

- disconnect the recovery unit.

HOW TO DISCONNECT AND REMOVE EMIX UNIT

Emix could be connected to any type of thermal solar system, both natural and forced circulation.

In case of forced circulation solar system, by the water point of view, Emix must be connected to the solar tank exactly

like any other tank in parallel to the cold and hot tap water (mixing valve); by the electric point of view Emix could be

submitted to the solar control box if it has a dry contact to enable/disable Emix energy support to the water. In case the

solar control box does not have any backup contact, Emix will run in parallel mode with the solar system and obviously

will stop immediately the operation if the water is already hot by the sun. See section “Home Automation connections”

for connection to an external input signal.

In case of solar panel with natural circulation, the tank of the panel is equivalent to the normal tank connected to the

Emix. Connect in parallel the cold and hot tap water is enough to make working together the solar panel and Emix, but

take care about two important matters:

• elevation between Emix and solar tank cannot be more than the 7,5 meters, the max. elevation supported by the

Emix water pump to work properly;

• higher temperature of water due by the sun in some geographical areas; if the water temperature exceeds 95°C is

better to install a security system in temperature, in order to avoid over temperature of the Emix internal components.

(check hydraulic layouts).

HOW TO CONNECT EMIX TO A SOLAR THERMAL SYSTEM

INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH THE EUROPEAN

DIRECTIVE 2012/19/EU

At the end of its working life this equipment must not be disposed of as an household waste.

It must be taken to special local community waste collection centres or to a dealer providing this service.

Disposing of an electrical and electronic equipment separately avoids possible negative effects on the environment

and human health deriving from an inappropriate disposal and enables its components to be recovered and recycled

to obtain significant savings in energy and resources.

In order to underline the duty to dispose of this equipment separately, the product is marked with a crossed-out dustbin.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Argo Emix Tank Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Argo Emix Tank

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info