Bedienungsanleitung Argo Eris Plus (Seite 9 von 16) (Englisch)

724688

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

V 11/19

HOW TO USE THE APPLIANCE

This appliance can be used for cooling, dehumidifying and ventilating.

When switching between modes, the fan continues to rotate but the compressor stops: the compressor will start after 3

minutes. This delay protects the compressor from potential damage.

Cooling, Fan, Heating* (*available only on IRO PLUS) Dehumidifying

THE DISCHARGE TUBE MUST ALWAYS BE CONNECTED to the appliance: the only exception is when the

appliance is used solely for dehumidification, in which case it is advisable to let the appliance discharge directly

into the environment for maximum efficiency (consult the "Dehumidification Mode" paragraph).

Regularly clean the air filters beneath the easily removable rear grille to keep the air conditioner working efficiently.

OPERATING MODES

1. COOLING MODE (COOL)

 The “Cool” LED on the control panel will turn on.

 The temperature can be adjusted to between 16 °C and 31 °C.

 In this mode, each time the ON/OFF button is pressed the unit switches off, the appliance saves the

temperature

 setting and retains this setting when it is switched on again.

 In this mode, the fan speed can be adjusted and the Timer and SLEEP functions can be set.

 For more silent operation, run the fan at low speed.

2. HEATING MODE (HEAT)*

 The “Heat” LED on the control panel will turn on.

 The temperature can be adjusted to between 16 °C and 31 °C.

 In this mode, each time the ON/OFF button is pressed the unit switches off, the appliance saves the

temperature

 setting and retains this setting when it is switched on again.

 In this mode, the fan speed can be adjusted and the Timer and SLEEP functions can be set.

 For more silent operation, run the fan at low speed.

*Available only in IRO PLUS model.

3. DEHUMIDIFICATION MODE (DRY)

 Press the MODE button to select the dehumidification mode.

 The temperature is controlled by the electronic board and cannot be adjusted.

 In this mode, each time the ON/OFF button is pressed the unit switches off, the appliance saves the settings

and

 retains them when it is switched on again.

 The fan speed is set to low and cannot be adjusted.

NOTE

The air conditioner does not cool the room when operating as a dehumidifier.

When the appliance is used as a dehumidifier, the flexible pipe must not be connected.

For maximum dehumidification efficiency, leave the rear discharge attachment free to discharge directly into

the environment.

The dehumidification mode is recommended during autumn and winter.

If used during summer, it is best to leave the flexible pipe attached so that the hot air is discharged towards

the outside rather than into the room.

During dehumidification, continuous drainage should be implemented (see the next chapter, “HOW TO ELIMINATE

CONDENSATE”).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Argo Eris Plus Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Argo Eris Plus

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info