Bedienungsanleitung Argo Kary (Seite 9 von 19) (Englisch)

805066

Zoom out

Zoom in

Vorherige Seite

1/19

Nächste Seite

28V 01/23

OPERATING MODES

1. COOLING MODE (COOL)

• Press the MODE button to select Cooling. The LED “COOL”on the control panel lights up.

• The temperature adjustment range goes from 15 °C to 31 °C with 1 °C steps.

• In this mode, every time the unit is switched off by pressing the ON/OFF button, the appliance stores the set

temperature and when it is switched on again it will keep the setting.

• In this mode it is possible to adjust the ventilation speed (Fan Speed) and set the Timer and SLEEP function.

• For quieter operation, reduce speed to low.

2. DEHUMIDIFICATION MODE (DRY)

• Press the MODE button to select Dehumidication. The LED “DEHUM”on the control panel lights up

• The temperature is set by default and cannot be adjusted.

• In this mode, every time the unit is switched off by pressing the ON/OFF button, the appliance memorizes

the settings and will keep them when it is switched on again.

• The fan speed is xed at low and cannot be adjusted.

NOTE: the air conditioner does not cool the room when operating as a dehumidier. When the appliance is

used as a dehumidier, the exible pipe must not be connected. For maximum dehumidication efciency, leave

the rear discharge attachment free to discharge directly into the environment. The dehumidication mode is

recommended during autumn and winter. If used during summer, it is best to leave the exible pipe attached so

that the hot air is discharged towards the outside rather than into the room. During dehumidication, continuous

drainage should be implemented (see the next chapter, “HOW TO ELIMINATE CONDENSATE”).

3. FAN MODE (FAN)

• Press the MODE button to select ventilation until the LED “FAN” lights up.

• In this mode, the fan speed can be adjusted.

• The temperature cannot be adjusted.

This appliance automatically vaporizes the condensate in Cooling mode.

Make sure that, when the unit works in Cooling mode, the rubber cap that

closes the drain hole on the back is correctly positioned. When the internal

tank is full of water, the air conditioner will emit acoustic signals and the display

will show the message E4, signaling that it has been lled and blocking unit

operation. To empty the container, turn off the air conditioner and unplug it.

Remove the plug from the lower drain hole, connect the supplied condensate

drain hose and place the end over a normal drain. Make sure the hose is free

from twists and bends. The pipe must have a descending trend. Close the

drain with the cap and resume using the air conditioner.

CONTINUOUS DRAINAGE

ATTENTION: when using the air conditioner in Dehumidication, it is advisable to always arrange for continuous

drainage of the condensate to ensure maximum dehumidication efciency. Use the bottom drainage hole. The

water can be drained into a drain by simply connecting the supplied hose. It is advisable to place a shim of a few

centimeters under the product to guarantee an adequate slope of the continuous condensate drain pipe.

HOW TO ELIMINATE CONDENSATE

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Argo Kary Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Argo Kary

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info