Bedienungsanleitung Argo LILIUM ART 11 - 13 (Seite 6 von 14) (Englisch)

805018

Zoom out

Zoom in

Vorherige Seite

1/14

Nächste Seite

V 02/22

The following space must be maintained to ensure the operating efficiency of the dehumidifier.

OPERATING INSTRUCTIONS

APPLIANCE START-UP

Place the product on a flat and stable heat-resistant surface, at least 1 metre away from flammable or heat-sensitive

materials and 50 cm away from walls or other obstructions.

Make sure the water tank is in the correct position

Connect the power cord to a suitable electric socket (220-240V～/1/50Hz).

Turn the appliance on with POWER on the control panel. The unit emits a sound signal and is in standby, the colored

LED on the front panel lights up. The display shows the humidity% detected in the room, therefore set a humidity %

lower than at least 3% compared to that in the room to make the dehumidifier work.

The dehumidifier is designed to operate at ambient temperatures from + 5°C to + 35°C.

If it is operated at low temperatures, ice may form on the evaporator, degrading its operation.

When this happens, the dehumidifier goes into defrost mode. The compressor stops, but the fan continues running.

The defrosting operation may start up and operate for some minutes; during the defrosting operation, the dehumidification

function may intermit: please don’t turn off the switch or pull out the power plug of the dehumidifier.

We recommend not using the dehumidifier in room temperatures lower than 5°C.

Do not remove the tank when the unit is in operation.

If you wish to make continuous draining of condensate, follow the instructions in the dedicated paragraph.

OPERATING PRECAUTIONS

The dehumidifier starts only if the humidity level in the room is higher than 3% the set one.

The dehumidifier will continue to operate until the set humidity level is reached, except for any interruptions due

to filling the tank.

When the water tank is full, the compressor stops running immediately and dehumidification stops; the fan stops after 3

minutes. Empty the tank and reposition it: after carrying out these operations, the unit will start operating again.

ATTENTION:

After each interruption of operation, at least 3 minutes must elapse before the dehumidifier restarts: this start-

up delay protects the compressor from damage.

If, on the other hand, the humidity% set is higher than that present in the room, the dehumidifier will not start.

If, after following the instructions for starting the dehumidifier, the dehumidifier does not start and the (POWER) symbol

does not light up, or the dehumidifier stops without reason, check that the condition of the plug and the power cord are

good. Once this is done, wait 10 minutes and then restart the dehumidifier.

If, even after 10 minutes, the dehumidifier does not start, or if the cable or the plug are damaged, switch off the

dehumidifier and contact a technical assistance center.

WARNING:

When the dehumidifier is running, the compressor produces heat and the appliance emits warm air into the

room. The room temperature will therefore tend to increase. This is completely normal.

50 cm

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Argo LILIUM ART 11 - 13 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Argo LILIUM ART 11 - 13

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info