Bedienungsanleitung Argo Luft (Seite 9 von 20) (Englisch)

805040

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

29V 12/22

HOW TO USE THE APPLIANCE

OPERATING MODES

This appliance can be used for cooling, dehumidifying and ventilation purposes. Before using the appliance, leave

it standing erect for at least two hours. When switching between modes, the fan continues to turn but the compressor

stops: the compressor will re-start after 3 minutes. This delay protects the compressor from potential damage. This

appliance is equipped with an automatic defrosting system. When the appliance starts defrosting, the Power LED

ashes on the control panel. In cooling and dehumidication mode, the compressor stops for 10 minutes, after which

the appliance continues to operate regularly.

THE DRAINAGE TUBE MUST BE CONNECTED to the appliance AT ALL TIMES: the only exception is when the

appliance is used in dehumidication mode only, in which case the appliance should be left to discharge directly

into the room for maximum efciency (see the “Dehumidication Mode” paragraph).

Clean the air lters under the easily removable rear grille regularly to keep the air conditioner working efciently.

1. COOLING MODE (COOL)

• The “Cool” LED on the control panel will turn on.

• The temperature can be adjusted to between 16 °C and 32 °C.

• In this mode, each time the ON/OFF button is pressed the unit switches off, the appliance saves the

temperature setting and retains this setting when it is switched on again.

• In this mode, the fan speed can be adjusted and the Timer and SLEEP functions can be set.

• For more silent operation, run the fan at low speed.

2. DEHUMIDIFICATION MODE (DRY)

• Press the MODE button to select the dehumidication mode.

• The temperature is controlled by the electronic board and cannot be adjusted.

• In this mode, each time the ON/OFF button is pressed the unit switches off, the appliance saves the settings

and retains them when it is switched on again.

• The fan speed is set to low and cannot be adjusted.

NOTE: the air conditioner does not cool the room when operating as a dehumidier. When the appliance is

used as a dehumidier, the exible pipe must not be connected. For maximum dehumidication efciency, leave

the rear discharge attachment free to discharge directly into the environment. The dehumidication mode is

recommended during autumn and winter. If used during summer, it is best to leave the exible pipe attached so

that the hot air is discharged towards the outside rather than into the room. During dehumidication, continuous

drainage should be implemented (see the next chapter, “HOW TO ELIMINATE CONDENSATE”).

3. FAN MODE (FAN)

• Press the MODE button to select ventilation until the corresponding icon appears.

• In this mode, the fan speed can be adjusted.

• The temperature cannot be adjusted.

Cooling, Fan Dehumidifying

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Argo Luft Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Argo Luft

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info