Bedienungsanleitung Argo Maxime Plus EU (Seite 11 von 41) (Englisch)

805050

Zoom out

Zoom in

Vorherige Seite

1/41

Nächste Seite

V 12/21 52

 In this mode, the fan speed can be adjusted and the Timer and SLEEP functions can be set.

 For more silent operation, run the fan at low speed.

 During heating mode It may be advisable to arrange the continuous drainage of condensate (see next chapter

CONDENSATE ELIMINATION METHOD)

 Under heating mode, when the set point is reached, turn off, and internal fan motor(the upper one) keeps

operation for 10s and then stop; the external fan motor(the lower one) continues the operation at low fan speed

3. DEHUMIDIFICATION MODE (DRY)

 Press the MODE button to select Dry.

 The “Dry” LED on the control panel lights up

 The temperature is controlled by the PCB and cannot be regulated.

 In this mode, whenever the ON/OFF button is pressed, the unit switches off, the appliance saves the settings

and, when switched back on again, retains them.

 The fan speed is set to low and cannot be adjusted.

NOTE

The air conditioner does not cool the room when it is used as a dehumidifier.

When the appliance is used as a dehumidifier, the flexible hose must not be connected.

For maximum dehumidification efficiency, leave the rear discharge attachment free to discharge directly

into the environment.

The dehumidification mode is recommended during autumn and winter.

If used in summer, it is best to leave the flexible hose attached so that the hot air can be discharged

towards the outside rather than into the room.

During dehumidification, continuous drainage of condensate should be implemented (consult the next chapter,

"CONDENSATE ELIMINATION").

4. VENTILATION MODE (FAN ONLY)

 Press the MODE button to select Fan and wait until the relative icon appears.

 In this mode, the fan speed can be adjusted.

 The temperature cannot be adjusted.

HOW TO ELIMINATE CONDENSATE

In cooling mode this appliance automatically vaporizes the condensate; only in particular climatic conditions, in which

the humidity rate of the air is very high, can it happen that water is deposited inside the internal tank. In heating it is

normal for water to be collected in the internal tank. When the internal tank is full, the air conditioner will emit 8

beeps and the display will show the message "H8", signaling the filling and blocking the operation of the

device. In Heating, it is possible, if desired, to arrange the continuous drainage of the condensate from the lower hole,

taking care to position the unit on a small rise in order to ensure the necessary slope to the drainage pipe.

Cooling and Heating

When the unit operates in the cooling and heating mode, ensure that the

rubber cap closing the drainage opening on the back of the appliance is

properly positioned.

To empty the container, switch the air conditioner off and unplug the cord.

Remove the cap from the rear drainage opening and place its end over a

normal drain. Ensure that the tube is not twisted or bent. The tube must

slope downwards. Re-close the drainage opening with the cap, insert it into

the clamp and resume use of the air conditioner.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Argo Maxime Plus EU Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Argo Maxime Plus EU

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info