Bedienungsanleitung Argo Newage (Seite 49 von 61) (Englisch)

805095

Zoom out

Zoom in

Vorherige Seite

1/61

Nächste Seite

49V 11/22

• Keep leak detector in working state during the installation.

• If R32 refrigerant leakage occurs during the installation, you shall immediately detect the concentration in indoor

environment until it reaches a safe level. If refrigerant leakage affects the performance of the air conditioner,

please immediately stop the operation, and the air conditioner must be vacuumed rstly and be returned to the

maintenance station for processing.

• Keep electric appliance, power switch, plug, socket, high temperature heat source and high static away from the

area underneath sidelines of the indoor unit.

• The air conditioner shall be installed in an accessible location to installation and maintenance, without obstacles

that may block air inlets or outlets of indoor/outdoor units, and shall keep away from heat source, inammable

or explosive conditions.

• When installing or repairing the air conditioner and the connecting line is not long enough, the entire connecting

line shall be replaced with the connecting line of the original specication; extension is not allowed.

• Use new connection pipe, unless re-aring the pipe.

REQUIREMENTS FOR INSTALLATION

• Avoid places of inammable or explosive gas leakage or where there are strongly aggressive gases.

• Avoid places subject to strong articial electric/magnetic elds.

• Avoid places subject to noise and resonance.

• Avoid severe natural conditions (e.g. heavy lampblack, strong sandy wind, direct sunshine or high temperature

heat sources).

• Avoid places within the reach of children.

• Shorten the connection between the indoor and outdoor units.

• Select where it is easy to perform service and repair and where the ventilation good.

• The outdoor unit shall not be installed in any way that could occupy an aisle, stairway, exit, re escape, catwalk

or any other public area.

• The outdoor unit shall be installed as far as possible from the doors and windows of the neighbors as well as the

green plants.

INSTALLATION ENVIRONMENT INSPECTION

• Check nameplate of outdoor unit to make sure whether the refrigerant is R32.

• Check the oor space of the room. The space shall not be less than usable space(5 m2) in the specication. The

outdoor unit shall be installed at a well-ventilated place.

• Check the surrounding environment of installation site: R32 shall not be installed in the enclosed reserved space

of a building.

• When using electric drill to make holes in the wall, check rst whether there is pre-buried pipeline for water,

electricity and gas. It is suggested to use the reserved hole in the roof of the wall.

REQUIREMENTS OF WALL INSTALLATION PLATE

• The wall installation plate must meet the relevant national or industrial standards in terms of strength with welding

and connection areas rustproofed.

• The wall installation plate and its load carry surface shall be able to withstand 4 times or above the weight of the

unit, or 200 kg, whichever is heavier.

• The wall installation plate of the outdoor unit shall be fastened with expansion bolt.

• Ensure the secure installation regardless of what type of wall on which it is installed, to prevent potential dropping

that could hurt people.

ELECTRICAL SAFETY REQUIREMENTS

• Be sure to use the rated voltage and air conditioners dedicated circuit for the power supply, and the power cable

diameter must meet the national requirements.

• When the maximum current of air conditioner is ≥16A, it must use the air switch or leakage protection switch

equipped with protection devices.

• The operating range is 90%-110% of the local rated voltage. But insufcient power supply malfunction, electrical

shock, or re. If the voltage instability, proposed to increase the voltage regulator.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Argo Newage Seite 49

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Argo Newage

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info