Bedienungsanleitung Argo Nikko (Seite 13 von 21) (Englisch)

805067

Zoom out

Zoom in

Vorherige Seite

1/21

Nächste Seite

35V 05/23

FUNCTION OF THE BUTTONS ON THE REMOTE CONTROLLER AND ON THE CONTROL PANEL

(the numbers below refer to the control panel drawing)

When the cable is connected to the power supply, the unit emits three beeps.

Press this button to turn the unit on or off. The unit beeps. All the LEDs of the buttons light up on the control panel,

and then turn off after a few seconds, while the LED of the POWER button remains on, but with a reduced intensity

of brightness.

When the unit is switched on, the ambient temperature is shown, and the unit enters Stand-by mode.

1. POWER BUTTON

Press this button on the control panel or remote controller to turn the unit on or off. The unit beeps.

When the unit is switched on, the temperature previously set in Cooling mode (Cool) is shown. Press this button

again to start the appliance operation.

The default settings are: Cooling mode, low fan speed.

2. SPEED BUTTON

Press this button on the control panel to select the desired fan speed from Low, High, Auto, in the following circular

sequence:

The corresponding LEDs light up on the control panel according to your selection.

The Auto fan speed can be selected only in the Cooling and Ventilation modes.

3. MODE BUTTON

Press this button on the control panel to select the operating mode among: Automatic (AUTO), Cooling (Cool),

Dehumidication (Dry), Ventilation (Fan) in the following circular sequence:

The corresponding LEDs on the display light up on the control panel according to the selection made. The LED ring

located on the front of the appliance changes color according to the selected operating mode:

- Cooling (Cool): blue

- Dehumidication (Dry): white

- Ventilation (Fan): Green

- In the Dehumidication (DRY) operating mode, it is not possible to select the fan speed.

On the remote controller, press the Mode button to select the operating mode in the following circular sequence:

Cooling (Cool), Dehumidication (Dry), Ventilation (Fan), Automatic (AUTO).

It is also possible to directly select the desired operating mode by pressing the COLD (cooling), AUTO (automatic),

DRY (dehumidication). To set FAN mode (ventilation), press MODE button, the icon lights up and Fn appears on

remote controller display..

The corresponding icons light up on the remote controller display according to the selection made.

4. UP/DOWN BUTTONS

Press these buttons on the control panel or on the remote controller to adjust the temperature (each time you press

the temperature increases or decreases by 1°C) and set the Timer (each time you press the time increases or

decreases by 1 hour).

5. TIMER BUTTON

By control panel:

• When the air conditioner is off, press “TIMER” to set a time to turn on the unit. Press “UP” or “DOWN“ to set

the hour, and press “TIMER” again to conrm.

• When the air conditioner is on, press “TIMER” to set a time to turn off the unit. Press “UP” or “DOWN“ to set

the hour, and press “TIMER” again to conrm.

To set the switch-off or switch-on time of the appliance, press the Timer button, “00” will ash on the display for

three seconds, with the UP/DOWN buttons it is possible to select the desired time. Timer time selection range is

0-24 hours. Then press the Timer button to conrm the chosen time.

To cancel the Timer function, press and hold the button for about 3 seconds.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Argo Nikko Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Argo Nikko

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info