Bedienungsanleitung Argo PLATINUM EVO 21 (Seite 8 von 12) (Englisch)

724749

Zoom out

Zoom in

Vorherige Seite

1/12

Nächste Seite

V 01/20

CONTROL PANEL

BUTTONS

(1) ON/OFF BUTTON:

press to turn the dehumidifier on and off.

(2) FAN BUTTON: press to adjust the fan speed: High, Med, Low.

(3) ON/OFF TIMER BUTTON: the unit can be programmed to switch on (when it is off) and switch off(when it is running)

at increments of 1 hour, from 1 to 24 hours. After setting it, the display will show the time per 5".

(4) HUMIDITY BUTTON: In SMART and QUIET mode, the humidity can be adjusted from 30% to 80% at increments of

10%. After setting it, the display will show the set humidity. The appliance will only start operating if the humidity

level in the room is above the set value.

(5) MODE BUTTON: you can select one of the following dehumidification modes: the corresponding LED will turn on.

 Smart: the unit will intelligently select the optimum humidity level based on the current temperature.

 Cont (Continuous): the unit will run continuously until the room humidity has reached 50%.

 Quiet: the unit will intelligently select the optimum humidity level based on the temperature; the fan is kept to a

minimum to ensure it is as quiet as possible. In this mode, the fan cannot be adjusted.

 Dry: special laundry drying feature: the airflow is directed straight up to make it easier to dry the clothes.

(6) WIND DIRECT BUTTON: you can select to make the deflector swing continuously to optimize the airflow around the

room, or decide where to fasten the flap (fixed angle).

LED

FILTER CLEAN LED (CLEAN FILTER SYSTEM): THE

FILTER CLEAN LED will turn on to indicate that the filter must

be cleaned. Take the filter out and clean it. Then press the FAN and HUMIDITY button at the same time to turn off the

Filter Clean LED.

WATER FULL LED: when the tank is full, the WATER FULL LED will come on and the appliance will stop running. A

beep will sound lasting approximately 10 seconds. Remove the tank and empty it (as described in "HOW TO REMOVE

CONDENSATION"), then reposition it correctly; the dehumidifier will start running again.

TANK FULL ALARM: when the internal tank is full, or the tank is not correctly positioned, the unit will sound a beep

lasting approximately 10": then the LED will turn on. Empty the tank or reposition it correctly.

DEFLECTOR POSITION LED: this indicates your selection of a continuous swing or a fixed angle flap position.

DEHUMIDIFICATION MODE LED: this indicates your selected mode.

DISPLAY: this shows the set humidity.

TIMER LED: this indicates the time it is set to on or off.

TANK FULL LED

TIMER LED

FILTER RESET

LED

HIGH-MEDIUM-LOW

FAN SPEED LED

(1)

ON/OFF

BUTTON

(2) (3) (4) (5)

(6)

HUMIDITY

SETTING

TIMER

FAN

DEHUMIDIFICATION

MODE LED

DEFLECTOR

POSITION LED

DISPLAY

AIR FLOW

DIRECTION

SETTING

DEHUMIDIFICATION

MODE SELECTION:

- SMART

- CONTINUOUS

- QUIET

- DRY

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Argo PLATINUM EVO 21 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Argo PLATINUM EVO 21

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info