Bedienungsanleitung Argo Wall Mono 18000 (Seite 15 von 27) (Englisch)

665462

Zoom out

Zoom in

Vorherige Seite

1/27

Nächste Seite

V 11/15

Outdoor unit

1. Choose a location where the noise and airflow produced by the outdoor unit will not annoy neighbours.

2. The location should be well ventilated and dry; the outdoor unit must not be exposed to direct sunlight

or strong winds.

3. The site should be able to support the weight of the outdoor unit.

4. Check that the installation complies with the requirements of the dimensional drawing for installation.

5. Choose a location out of the reach of children and away from animals or plants. If this is not possible,

install safety fencing.

Electrical connection requirements

Safety precautions

1. Electrical safety standards must be met when installing the unit.

2. Use a power supply circuit and circuit breaker that comply with local safety regulations.

3. Make sure that the power supply matches the requirements of the air conditioner. An

unstable power supply or incorrect wiring may result in a fault. Install suitable power cables

before switching on the air conditioner.

4. Correctly connect the live, neutral and earth wires to the power outlet.

5. Disconnect the power supply before carrying out any work on the electrical circuit or

carrying out any safety work. For models with a plug, make sure the plug is easily

accessible after installation.

6. Do not connect the power before installation is complete.

7. Do not use the appliance if the power cable or plug are damaged. If the power cable is

damaged it must be replaced by the manufacturer, retailer or other qualified person to avoid

a hazard.

8. Since the temperature of the cooling circuit is high, keep the interconnecting cable away

from the copper pipe.

9. The unit must be installed in accordance with national wiring regulations.

10. Installation must only be performed by trained individuals in accordance with regulations.

Earthing

1. The air conditioner is a Class I appliance. The unit must be earthed with an appropriate

device by a qualified technician. Ensure the unit is always properly earthed. Otherwise

electric shock may result.

1. The green-yellow wire of the air conditioner is the earthing wire and may not be used for

other purposes.

2. The earth resistance must meet national standards for electrical safety.

3. The unit must be positioned so that the plug is accessible.

4. An all-pole isolating switch with a minimum contact gap of 3mm in each pole must be

connected to the fixed cable.

5. Install a circuit breaker of sufficient capacity and note the following table. The air switch

must include a thermal and magnetic trip function to protect against short circuits and

overloads. (Warning: do not use only the fuse to protect the circuit)

Air conditioner Circuit breaker capacity

09-12-18K 10 A

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Argo Wall Mono 18000 Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Argo Wall Mono 18000

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info