to stop shooting. Then the photos can be downloaded one by one.
2. The camera will regain previous status after shooting and releasing of
shutter button.
Note: Under the continuous shooting mode, the shooting may fail due to
poor lighting.
Deleting All Photos
1. Upon starting of camera, press delete function button for two times and
select the “ ” icon shown on the LCD display.
2. Pressing the shutter button again within 5 seconds will delete all the
photos stored in the memory. Then this function will be eliminated.
Deleting Single Photo
1. Upon starting of camera, press delete function button for one time and
select the “ ” icon shown on the LCD display.
2. Press the shutter button within 5 seconds once to delete the last photo
taken.This function will be eliminated later.
Flash
Upon starting of camera, move Flash Slide Switch to the end with flash sign
and the flash will being charging. About 6 seconds later, LED will be on, which
means fully charging. Press shutter button, Photo will be taken with flash Then
LED will be out. About 6 seconds later, LED will be on (the charging time will
be different with battery capacity) again for shooting. (Under flash mode, press
the shutter button only after full charging in order to avoid chip failure.)
The camera cannot take photo if the ambient light is totally insufficient
Note: To make sure the quality of photo, it’s highly recommended to use the
flash indoors and at night. The best effective flash distance is within1.5M.
