47637
4
Zoom out
Zoom in
Vorherige Seite
1/20
Nächste Seite
M
ARGHERITA
Margherita - Instructions for installation and use
I
G
L
F
E
H
N
M O
A
B
C
D
Stain removal (see page 8)
Thanks to this command, Mar-
gherita will carry out a more in-
tensive wash that optimises the
effectiveness of the liquid
additives, thus allowing more
resistant stains to be removed.
When you press the stain removal
button, you cannot activate the
pre-wash cycle (I).
Prewash
With this button, you can pre-
wash on all programmes except
the wool programme and the
special programmes (see page 4).
If you use this function, you
cannot use the stain removal
button (H).
On-off
When button L is pressed, the
washer-dryer is switched on,
when it is not the machine is
switched off. Turning the
appliance off does not cancel
the selected programme.
On-off lamp / door locked
Lamp M flashes slowly when the
appliance is switched on and
awaiting instructions and at the end
of a cycle, indicating that the door
can be opened. It flashes quickly
when the door should not be
opened. A steady light means the
appliance has accepted the selected
programme.
Drying cycle lamp
When this lamp is on, it means
that knob C has been set on a
drying cycle and at the end of the
wash cycle, the appliance will run
the selected tumble drying cycle.
The washer-dryer is equipped
with extra compartment 4
(provided) for the bleach, to be
inserted in compartment 1.
Programme key
This contains the descriptions of
the wash programmes and the
various functions connected to
the buttons. Pull it outwards to
open it.
Rinse-hold
This button allows you to interrupt
a programme (on symbol
)
keeping the washing soaking in
water before the spin cycle. It is a
very useful button in particular
because it can be used for
delicates and synthetics. It is only
to be used with wash programmes
for synthetic fabrics, silk and
curtains when it is impossible for
you to take the washing out
immediately. Before opening the
washing machine door, finish the
wash cycle as follows:
Silk and curtains: press button F
and Margherita will drain the
water.
Synthetic fabrics: press button F
if you want a spin cycle, or turn
knob A to symbol if you want
the water to be drained.
N.B.:
- when setting a drying cycle,
this function is not performed.
- With "Daily wash" or "Hand
wash", this function is not
performed.
Slow spin
Use this button to reduce the
spinning speed from 1200 to 600
rpm for the cotton programmes
and from 850 to 600 rpm for the
synthetic fabrics programmes.
Here Im in command
Understanding the control panel
Making the right choice is important. And its easy.
Margheritas knobs are hidden. Just
press them lightly in the middle to
extract them.
Programme selector knob
and programmed start
Use this knob to select the wash
programme.
Turn this knob clockwise only.
To select a programme, you
should turn the knob so that the
symbol/number of the desired
programme is in line with the
pointer on the glass O.
Now press on/off button L
(position ON), pilot lamp M will
start flashing.
After 5", the setting will be
accepted, pilot lamp M will stop
flashing (staying lit) and the wash
cycle will begin.
Should you wish to interrupt the
programme in progress or set a
new one, select one of the
symbols
(Stop/Reset) and wait
5" : when the cancellation has
been accepted, pilot lamp M
flashes, and you can then turn the
appliance off.
You can use this knob to delay
the appliance's operation.
Select one of the 3 delay time
positions, press the on/off button
L (position ON) and wait 5". The
setting has now been accepted
(pilot lamp M stays lit) and you
can select the programme you
desire.
Pilot lamp M has a particular
flashing motion (2" on and 4"
off) to indicate that a delayed
start has been set.
During this phase, you can open
the appliance door and change
the washing load, should you
wish to do so.
After the wash cycle has been set
and accepted by the washer-
dryer, turning the knob will have
no effect (except for when it is
on position Stop/Reset).
Temperature control knob
It is used to set the wash tempe-
rature indicated in the
programme table. It also allows
you to reduce the temperature
recommended for the selected
programme, and even to set a
cold wash cycle ( ).
Drying cycle knob
Use this knob to select the desired
drying cycle. Two options are
available:
A - Based on time:
From 40 minutes to 150.
B - Based on the damp level of
the dry clothes:
Iron
: slightly damp clothes,
easy to iron.
Wardrobe : dry clothes to put
away.
Extra dry : very dry clothes,
recommended for towelling and
bathrobes.
A cooling stage is foreseen at the
end of the drying cycle.
Detergent dispenser
It is divided into three
compartments:
1. Detergent for pre-washing;
2. Detergent for the wash cycle;
3. Fabric softeners,
starches, perfumes.
The detergent dispenser with
the additional bleach
compartment is here.
3
M
A
X
1
2
4
3
4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Ariston ALD12 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info