Bedienungsanleitung Ariston ALYS (Seite 40 von 152) (Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

579881

Zoom out

Zoom in

Vorherige Seite

1/152

Nächste Seite

2. PIPING AND CONNECTIONS

WARNING:

- Only use piping speciﬁ cally designed for ACR air conditioning

units.

- Protect all connection cables and pipes in order to prevent their

being damaged.

- Never use pipes with a thickness of under 0.8 mm.

- The appliance must be installed in full compliance with national

system regulations.

- During the installation process, the refrigeration system should

be connected ﬁ rst, followed by the electricity supply. In the

event of replacement, proceed in the reverse order.

WARNING:

- Do not drink the condensation water (personal injury from poi-

soning).

- Position the condensation drain pipe in such a way as to allow

for the correct downward ﬂ ow of water in dedicated areas, and

to prevent any inconvenience or damage to people, things, ani-

mals, plants and structures.

- Use manual tools and equipment that are suitable for the in-

tended purpose.

2.1 Connecting the refrigeration piping

The piping can be positioned in different directions as indicated by

numbers 1, 2, 3, 4 and 5 in the adjacent ﬁ gure. When the pipes are po-

sitioned in directions 1, 3 or 5, the special groove marked on the side

of the internal unit should be cut using a suitable tool. Turn the pipes

in the direction of the hole in the wall, taking care not to constrict

them in any way, and tape the refrigeration system piping, condensa-

tion drain pipe and electrical wiring together with electric (insulating)

tape, keeping the condensation drain pipe at the bottom so that the

water can ﬂ ow freely.

2.2 Draining the condensation from the internal unit

The proper draining of condensation from the internal unit is funda-

mental for a good installation.

1. Keep the condensation drain pipe (diameter 16,5 mm) at the bot-

tom of the hole in the wall.

2. Make sure the condensation drain pipe has a continuous gradient

of approximately 3 cm per metre.

3. Do not include any traps in the condensation discharge piping.

4. Do not immerse the free end of the condensation drain pipe in wa-

ter and do not leave it in the vicinity of places emanating unpleas-

ant odours.

5. When the installation is complete, before switching on the appli-

ance, make sure the condensation drain pipe works properly by

pouring some water into the condensation drip water tray situated

inside the internal unit.

2.3 Draining the condensation from the external unit

The condensation or water that forms in the external unit during op-

eration in heating mode can be removed via the drain pipe ﬁ tting.

Installation: fasten the drain pipe ﬁ tting (diameter 16 mm) to the hole

on the bottom of the unit, as illustrated in the adjacent diagram. Con-

nect the condensation drain pipe to the drain pipe ﬁ tting and ensure

the other end of the pipe is ducted into a suitable drain.

PIPING INSULATION

CONDENSATION

DISCHARGE PIPE

REFRIGERATION

SYSTEM PIPING

REFRIGERATION

SYSTEM PIPING

SIGNAL CABLE

INSULATING SHEATH

YES NO NO

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ariston ALYS Seite 40

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info