Bedienungsanleitung Ariston C659PXUK (Seite 4 von 16) (Englisch)

47725

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

HOT PARTS

Important: make sure the supply pressure conforms with the

values shown in the table entitled “Caracteristics of the burners

and nozzles”. When the cooker is installed between cabinets

(recessed), the gas connection must be effected by an

approved flexible hose with bayonet fitting

(BS 669 Current Edition). The gas inlet for the cookers is a

threaded G 1/2 gas female fitting.

Connecting the gas supply

To make the connection, a flexible hose should be used

corresponding to the current gas regulations which are:

• the hose must never be at any point in its lenght in contact

with the “hot” parts of the cooker;

• the hose must never be longer than 1,5 metre;

• the hose must not be subject to any tension or torsional

stress and it must not have any excessively narrow curves

or bottlenecks;

• the hose must be easy to inspect along its entire length to

check its condition;

• the hose must always be in good condition, never attempt

to repair.

Important: the installation must comply with gas safety

(installation and use) regulations 1984. In all cases for the above,

by low, a qualified, corgi approved engineer must be called for

installation.

Electrial connection

Power supply voltage and frequency: 230-240V a.c. 50 Hz.

Note: the supply cable must be positioned so that it never

reaches at any point a temperature 50°C higher than the room

temperature. The cable must be routed away from the rear vents.

Should you require it, you may use a longer cable, however,

you must ensure that the cable supplied with the appliance is

replaced by one of the same specifications in accordance with

current standards and legislation.

Your appliance is supplied with a 13 amp fused plug that can be

plugged into a 13 amp socket for immediate use. Before using

the appliance please read the instructions below.

WARNING - THIS APPLIANCE MUST BE EARTHED.

THE FOLLOWING OPERATIONS SHOULD BE CARRIED

OUT BY A QUALIFIED ELECTRICIAN.

Replacing the fuse:

When replacing a faulty fuse, a 13 amp ASTA approved fuse to

BS 1362 should always be used, and the fuse cover re-fitted. If

the fuse cover is lost, the plug must not be used until a

replacement is obtained.

Replacement fuse covers:

If a replacement fuse cover is fitted, it must be of the correct

colour as indicated by the coloured marking or the colour that is

embossed in words on the base of the plug. Replacements can

be obtained directly from your nearest Service Depot.

Removing the plug:

If your appliance has a non-rewireable moulded plug and you

should wish to remove it to add a cable extension or to re-route

the mains cable through partitions, units etc., please ensure

that either:

• the plug is replaced by a fused 13 amp re-wireable plug

bearing the BSI mark of approval.

or:

• the mains cable is wired directly into a 13 amp cable outlet,

controlled by a switch, (in compliance with BS 5733) which

is accessible without moving the appliance.

Please note: for appliances with a rating greater than 13 amp

(eg: electric hob, double ovens and freestanding electric cookers

etc.) the mains cable must be wired into a cooker output point

with a rating of 45 amp. In this case the cable is not supplied.

Disposing of the plug:

Ensure that before disposing of the plug itself, you make the

pins unusable so that it cannot be accidentally inserted into a

socket. Instructions for connecting cable to an alternative plug:

Important: the wires in the mains lead are coloured in

accordance with the following code:

Green & Yellow - Earth

Blue - Neutral

Brown - Live

If the colours of the wires in the mains lead do not correspond

with the coloured markings identifying the terminals in your plug,

proceed as follows:

Connect Green & Yellow wire to terminal marked “E” or or

coloured Green or Green & Yellow.

Connect Brown wire to terminal marked “L” or coloured Red.

Connect Blue wire to terminal marked “N” or coloured Black.

If a 13 amp plug (BS 1363) is used it must be fitted with a 13

amp fuse. A 15 amp plug must be protected by a 15 amp fuse,

either in the plug or adaptor or at the distribution board. If you

are in any doubt about the electrical supply to your machine,

consult a qualified electrician before use.

How to connect an alternative plug:

The wires in this mains lead are coloured in accordance with

the following code:

BLUE “NEUTRAL” (“N”)

BROWN “LIVE” (“L”)

GREEN AND YELLOW “EARTH” (“E”)

GREEN &

YELLOW

BROWN

BLUE

13 amp fuse

CROSS-BAR

CORD GRIP

Disposing of the appliance

When disposing of the appliance please remove the plug by

cutting the mains cable as close as possible to the plug body

and dispose of it as described above.

Adapting the cooker to different types of gas

In order to adapt the cooker to a different type of gas with

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ariston C659PXUK Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info