Bedienungsanleitung Ariston CP 059 MT.2 S (Seite 24 von 72) (Englisch, Französisch, Italienisch, Portugiesisch, Spanisch)

507046

Zoom out

Zoom in

Vorherige Seite

1/72

Nächste Seite

Installation

! Before placing your new appliance into operation please

read these operating instructions carefully. It contains

important information concerning the safe installation and

operation of the appliance.

! Please keep these operating instructions for future

reference. Make sure that the instructions are kept with the

appliance if it is sold, given away or moved.

! The appliance must be installed by a qualied professional

in accordance with the instructions provided.

! Any necessary adjustment or maintenance must be

performed after the cooker has been disconnected from

the electricity supply.

Room ventilation

The appliance may only be installed in permanently-

ventilated rooms, according to current national legislation.

The room in which the appliance is installed must be

ventilated adequately in order to provide as much air as is

needed by the normal gas combustion process (the ow of

air must not be lower than 2 m

/h per kW of installed power).

The air inlets, protected by grilles, should have a duct

with an inner cross section of at least 100 cm

and should

be positioned so that they are not liable to even partial

obstruction (see gure A).

These inlets should be enlarged by 100% - with a minimum of

200 cm

- whenever the surface of the hob is not equipped with

a ame failure safety device. When the ow of air is provided in

an indirect manner from adjacent rooms (see gure B), provided

that these are not communal parts of a building, areas with

increased re hazards or bedrooms, the inlets should be tted

with a ventilation duct leading outside as described above.

Examples of

ventilation holes

for comburant air.

Enlarging the ventilation slot

between window and floor.

Adjacent

Room

Room to be

Vented

A B

! After prolonged use of the appliance, it is advisable to open

a window or increase the speed of any fans used.

Disposing of combustion fumes

The efcient disposal of combustion fumes should be

guaranteed using a hood which is connected to a safe

and efcient natural suction chimney, or using an electric

fan which begins to operate automatically every time the

appliance is switched on (see gure).

In a chimney stack or branched flue.

(exclusively for cooking appliances)

Directly to

the Outside

! The liqueed petroleum gases are heavier than air and

collect by the oor, therefore all rooms containing LPG

cylinders must have openings leading outside so that any

leaked gas can escape easily.

LPG cylinders, therefore, whether partially or completely full,

must not be installed or stored in rooms or storage areas which

are below ground level (cellars, etc.). Only the cylinder being

used should be stored in the room; this should also be kept well

away from sources of heat (ovens, chimneys, stoves) which

may cause the temperature of the cylinder to rise above 50°C.

Positioning and levelling

! The appliance may be installed alongside any cupboards

whose height does not exceed that of the hob surface.

! Make sure that the wall in contact with the back of the appliance

is made from a non-ammable, heat-resistant material (T 90°C).

To install the appliance correctly:

• Place it in the kitchen, the dining room or the studio at

(not in the bathroom).

• If the top of the hob is higher than the cupboards, the

appliance must be installed at least 500 mm away from

them.

HOOD

420

Min.

min. 650 mm. with hood

min.

700 mm. without hood

mm.

600

Min. mm.

420

Min. mm.

• If the cooker is installed

underneath a wall cabinet, there

must be a minimum distance of 420

mm between this cabinet and the

top of the hob.

This distance should be increased

to 700 mm if the wall cabinets are

ammable (see gure).

• Do not position blinds behind the cooker or less than 200

mm away from its sides.

• Any hoods must be installed in accordance with the

instructions listed in the relevant operating manual.

Levelling

If it is necessary to level the

appliance, screw the adjustable

feet into the places provided on

each corner of the base of the

cooker (see gure).

Electrical connection

Install a standardised plug corresponding to the load indicated

on the appliance data plate (see Technical data table).

The appliance must be directly connected to the mains using

an omnipolar switch with a minimum contact opening of 3

mm installed between the appliance and the mains. The

switch must be suitable for the charge indicated and must

comply with current electrical regulations (the earthing wire

must not be interrupted by the switch). The supply cable

must be positioned so that it does not come into contact

with temperatures higher than 50°C at any point.

Before connecting the appliance to the power supply, make

sure that:

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ariston CP 059 MT.2 S Seite 24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info