Bedienungsanleitung Ariston CP 649 FT (Seite 28 von 88) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch)

591455

Zoom out

Zoom in

Vorherige Seite

1/88

Nächste Seite

ELECTRICAL CONNECTION

Those ovens equipped with a three-pole power supply cable

are designed to operate with an alternating current with the

voltage and frequency indicated on the data plate (located

on the appliance) and in the instruction booklet. The wire

for earthing the appliance is yellow-green in colour.

Fitting on a power supply cable

Opening the terminal board:

• Using a screwdriver, prise on the side tabs of the terminal

board cover;

• Pull open the cover of the terminal board.

To install the cable, proceed as follows:

• Remove the wire clamp screw and the three contact

screws L-N-

• Fasten the wires beneath the screwheads using the fol-

lowing colour scheme: Blue (N) Brown (L) Yellow-

Green

• Secure the supply cable in place with the clamp and

close the cover of the terminal board.

Connecting the supply cable to the mains

Install a standardised plug corresponding to the load

indicated on the data plate. When connecting the cable

directly to the mains, install an omnipolar circuit-breaker

with a minimum contact opening of 3 mm between the

appliance and the mains. The omnipolar circuit breaker

should be sized according to the load and should comply

with current regulations (the earth wire should not be

interrupted by the circuit breaker).

The supply cable must be in such a position that no part of

it can reach a temperature of 50°C above room temperature.

Before connecting to the power supply, make sure that:

• The electrical safety of this appliance can only be guar-

anteed if the cooker is correctly and efficiently earthed,

in compliance with regulations on electrical safety.

Always ensure that the earthing is efficient; if you have

any doubts call in a qualified technician to check the

system. The manufacturer denies all responsibility for

damage resulting from a system which has not been

earthed.

• Before plugging the appliance into the mains, check that

the specifications indicated on the date plate (on the

appliance and/or packaging) correspond to those of the

electrical and gas mains of your home.

• Check that the electrical capacity of the system and

sockets will support the maximum power of the

appliance, as indicated on the data plate. If in doubt,

consult a qualified technical engineer.

• If the socket and appliance plug are not compatible,

have the socket replaced with a suitable model by a

qualified technical engineer. The latter, in particular, will

also have to ensure that the cross section of the socket

cables are suitable for the power absorbed by the

appliance. The use of adapters, multiple sockets and/or

extensions, is not recommended. If their use cannot be

avoided, remember to use only single or multiple

adapters and extensions which comply with current

safety regulations. In these cases, never exceed the

maximum current capacity indicated on the single

adapter or extension and the maximum power indicated

on the multiple adapter. The plug and socket must be

easily accessible.

INSTRUCTIONS FOR THE INSTALLER

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ariston CP 649 FT Seite 28

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info