Bedienungsanleitung Ariston E-System One (Seite 34 von 80) (Englisch)

719961

Zoom out

Zoom in

Vorherige Seite

1/80

Nächste Seite

34 /

COMMISSIONING

Ignition procedure

Press the ON/OFF button on the control panel to switch on the

boiler. The display shows:

● the operating mode:

winter

summer

Only heating - E-SYSTEM ONE

● The gures indicate:

the ow temperature when no heating requests have been made

- the ow temperature in central heating mode

the temperature of the hot water set in domestic hot water

The carrying out of certain functions is shown:

Deaeration cycle started

Centrl Heating Post-circulation

D.H.W. circuit Post-circulation

Electricity supply

- Check that the voltage and frequency of the electricity supply

correspond to the data shown on the boiler data plate;

- Make sure that the earthing connection is efcient.

First ignition

1. Make sure that:

- The gas valve is closed;

- The electrical connection has been properly carried out.

Make sure that, in any case, the green/yellow earthing wire

is connected to an efcient earthing system;

- Use a screwdriver to lift the cap on the automatic air relief

valve;

- Switch on the boiler (by pressing the ON/

OFF button) and use the

mode button to

select the standby mode, where no hot

water or heating requests are made.

- Start the deaeration cycle by pressing

mode for 5 seconds

The boiler will start a deaeration cycle

lasting about 7 minutes (See below). If

you need to stop it press mode. During the deaeration cycle

open the manual air vent (2) on the heat exchanger and

close when clear water free of air is visible.

- At the end, check that the system is completely deaerated

and, if not, repeat the procedure.

- Bleed the air from the radiators;

- The exhaust duct for combustion products should be suitable

and free from any obstructions;

- Any necessary ventilation inlets in the room should be open

(type B installation).

- Check whether the condense trap contains water; if not, it

must be relled. If necessary, open the manual air vent on

the main exchanger until complete lling.

N.B.: if the boiler will not be used for long periods, the

trap should be lled before the boiler is started up again.

It is dangerous not to rell the siphon as fumes may be

released into the environment.

2. Open the gas cock and check the connection seals, including

the boiler connection joints, making sure that the meter does

not detect any passage of gas. Eliminate any leaks.

3. Start the boiler by selecting the heating or domestic hot

water operation using the

mode button.

Description of Function

Deaeration cycle

During the lling stage or if there is excess air in the system,

the deaeration cycle can be activated by holding the mode

button for 5 seconds. The boiler will start a cycle which lasts

approximately 7 minutes. When this is complete the menu screen

will be restored. The cycle may either be repeated, if necessary,

or stopped by pressing mode. Press the mode button until the

normal display screen is restored.

if the cycle is stopped be sure to

maNually VeNt the appliaNce.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ariston E-System One Seite 34

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Ariston E-System One

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info