Bedienungsanleitung Ariston EVOS 70 MC4 (Seite 21 von 88) (Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

566567

Zoom out

Zoom in

Vorherige Seite

1/88

Nächste Seite

2. PIPING AND CONNECTIONS

WARNING:

- Do not drink the condensation water (personal injury from poi-

soning).

- Position the condensation drain pipe in such a way as to allow

for the correct downﬂ ow of water in dedicated areas, and to

prevent any inconvenience or damage to people, things, ani-

mals, plants and structures.

- Use manual tools and equipment that are suitable for the in-

tended use.

2.1 Connecting the refrigeration piping

The piping can be positioned in 3 different directions as indicated with

numbers 1, 2 and 3 in the adjacent ﬁ gure. When the pipes are posi-

tioned in directions 1 or 3, the special groove designed on the side of

the internal unit should be cut using a suitable tool. Turn the pipes

in the direction of the hole in the wall (2), taking care not to constrict

them in any way, and tape the cooling piping, condensation drain pipe

and electrical wiring together with electric (insulating) tape, keeping

the condensation drain pipe at the bottom so that the water can ﬂ ow

freely.

2.2 Draining the condensation from the internal unit

The proper draining of condensation from the internal unit is funda-

mental for a good installation.

1. Keep the condensation drain pipe (Ø 16,5 mm) at the bottom of the

hole in the wall.

2. Make sure the condensation drain pipe has a continuous gradient

of approximately 3 cm per metre.

3. Do not include any traps in the condensation discharge piping.

4. Do not immerse the free end of the condensation drain pipe in wa-

ter and do not leave it in the vicinity of places emanating unpleas-

ant odours.

5. When the installation is complete, before turning on the appliance,

make sure the condensation drain pipe works properly by pouring

some water into the condensation drip water tray situated inside

the internal unit.

2.3 Draining the condensation from the external

unit

The condensation or water that forms in the external unit during op-

eration in heating mode can be removed via the drain pipe ﬁ tting. In-

stallation: fasten the drain pipe (Ø 16mm) ﬁ tting on the bottom of the

unit, as illustrated in the diagram on the right. Connect the condensa-

tion drain pipe to the drain pipe ﬁ tting and ensure the other end of the

pipe is ducted into a suitable drain.

PIPING INSULATION

CONDENSATE DIS-

CHARGE PIPE

REFRIGERATION

PIPING

REFRIGERATION

PIPING

SIGNAL CABLE

INSULATING SHEATH

WARNING:

- Only use specially designed piping for ACR type air conditioning units

- Protect all connection cables and pipes in order to prevent them being damaged.

- Never use pipes that have a thickness which is less than 0,8 mm.

- The appliance must be installed in full compliance with national system regulations.

- During the installation process, the refrigerator should be connected ﬁ rst, followed by the electricity supply. In

the event of replacement, proceed in the reverse order.

YES NO NO

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ariston EVOS 70 MC4 Seite 21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Ariston EVOS 70 MC4

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info