Bedienungsanleitung Ariston FM 54 T (Seite 13 von 42) (Englisch, Holländisch, Französisch, Italienisch, Spanisch, Finnisch)

454770

Zoom out

Zoom in

Vorherige Seite

1/42

Nächste Seite

- If the power supply cord has been damaged or needs to be

replaced;

- If the appliance breaks down or functions poorly; ask for original

spare parts.

It is a good idea to do the following:

- Only use the appliance to cook food, nothing else;

- Check the soundness of the appliance after it has been

unpacked;

- disconnect the appliance from the electrical mains if it is not

functioning properly and before cleaning or performing

maintenance;

- When the appliance is not used for an extended period of

time, cut off the supply of power and close the gas cock (if

present);

- Use cooking gloves to place cookware in the oven or when

removing it;

- Always grasp the oven door in the centre because the ends

may be hot due to the escape of hot air;

- Make sure that the control knobs are on the “•”/”o” setting

when the appliance is not in use;

- Cut the power supply chord after disconnecting it from the

mains when you decide not to use the appliance any longer.

• The manufacturer will not be held liable for any damages that

might arise out of incorrect installation or improper, incorrect

or unreasonable use of the appliance.

Installation

Important: The power supply to the appliance must be

cut off before any adjustments or maintenance work is

done on it.

Installation of Built-in Ovens

In order to insure that the built-in appliance functions

properly, the cabinet containing it must be appropriate.

The figure below gives the dimensions of the cutout for

installation under the counter or in a cabinet wall unit.

595 mm.

20 mm.

543 mm.

5 mm.

567 mm.

23 mm.

593 mm.

45 mm.

558 mm.

595 mm.

20 mm.

543 mm.

5 mm.

567 mm.

23 mm.

575-585 mm.

558 mm.

595 mm.

45 mm.

min.

45 mm.

min.

In order to ensure adequate ventilation, the back panel of

the cabinet must be removed. Installing the oven so that it

rests on two strips of wood is preferable.

In the case where the oven rests on a continuous, flat

surface, there must be an aperture of at least 45 x 560

mm.

560 mm.

45 mm.

The panels of the adjacent cabinets must be made of

heat resistant material. In particular, cabinets with a veneer

exterior must be assembled with glues able to withstand

temperatures of up to 100°C.

In compliance with current safety standards, contact with

the electrical parts of the oven must not be possible once

it has been installed.

All parts which ensure safe operation of the appliance must

not be able to be removed without the use of a tool.

Fastening the Oven to the Cabinet

1. Position the "A" brackets so that they are flush against

the oven support strips (B).

2. Position the cleats (C) on the "A" brackets as shown in

the figure so that the thickness of the sides of the

cabinet, indicated on the cleat, is facing you.

3. Fasten the brackets and the cleats to the edge of the

side of the cabinet using the "D" screws.

4. Fasten the oven to the cabinet using the screws and

plastic washers (E).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ariston FM 54 T Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info