Bedienungsanleitung Ariston FS 41 R (Seite 11 von 58) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

454786

Zoom out

Zoom in

Vorherige Seite

1/58

Nächste Seite

Electromechancial Start/End Cooking Programmer

The Cooking Programmer

The figure illustrates the controls for the programmer.

Knobs 1, 2 and 3 allow you to make all the necessary

settings.

Knob 1

When turned in the clockwise direction, it allows you to

correct the time setting on the digital clock (upon installa-

tion, after a power failure or when it runs fast or slow etc.).

Knob 2

When turned in the clockwise direction, it:

– sets the duration of the cooking time (max of 210 min-

utes);

– stops the acoustical signal ( setting);

– sets the oven on manual mode ( setting).

The symbols for the above appear in quadrant 4.

Knob 3

When pressed and turned in either the clockwise or coun-

terclockwise direction, it sets the start of the cooking time

displayed in quadrant 5. When the clock is adjusted, you

must check that the time on the clock is synchronized

with the time shown in quadrant 5.

Manual Operating Mode for the Oven

The oven can be used normally, i.e. without being pro-

grammed. In this case, knob 2 must be turned in the clock-

wise direction until the symbol appears in quadrant 4.

Semiautomatic Operating Mode

The start time is nornal and end cooking time is pro-

grammed:

prepare the food to be cooked; rotate knob 2 in the clock-

wise direction and set the number of minutes for the end

cooking time in quadrant 4; turn the oven knob to the de-

sired temperature. Make sure that the time on the clock is

synchronized with the time shown in quadrant 5.

Automatic Operating Mode

Arrange the food to be cooked; turn knob 2 in the clock-

wise direction, setting the length of the cooking time in

quadrant 4; press and rotate knob 3 in the clockwise di-

rection to set the cooking start time in quadrant 5; turn

the oven knob to the desired temperature setting. At the

end of the cooking time, the "0" in quadrant 4 will be aligned

with the marker; this indicates that the oven is no longer

operating. An acoustical signal will sound to indicate that

the cooking time is over.

To stop the signal, turn knob 2 in the clockwise direction

so that the symbol is aligned with the marker in quad-

rant 4.

Example of programmer setting for the automatic operat-

ing mode for the oven.

End cooking time: 7:00 p.m.

Length of cooking time: 2 hours.

Arrange the food that is to be cooked; turn knob 2 in the

clockwise direction, setting the length of the cooking time

(2 hours) in quadrant 4.; press and rotate knob 3 in the

clockwise direction, setting the end cooking time, 5:00, in

quadrant 5; turn the oven control knob to the temperature

setting desired.

After these settings have been made, the programmer

will automatically stop and start the oven at 5:00 and

7:00 respectively.

Timer

The programmer can also serve as a timer only if the oven

is not programmed for automatic operating mode and is

not on.

To use the timer feature, turn knob 2 in the clockwise di-

rection to set the time in quadrant 4. The maximum time

setting is 210 minutes. To stop the acoustical signal, turn

knob 2 in the clockwise direction until the symbol is

aligned with the marker in quadrant 4.

Programmed Cooking

Programmed cooking is no different than normal cooking.

The programmer does not control the cooking time setting

when you are not present or doing other work. Therefore,

it is best to use the completely automatic mode for foods

which do not require special attention. When programming

a time greater than 12 hours, it must always refer to the

first 12 hours of the day (e.g. 20:00 must be understood to

mean 8:00 and so forth). Therefore, it is possible to pro-

gram cooking 12 hours in advance.

Important

To use the oven manually (without the programmer), the

following is necessary:

1. Upon adjusting the clock, make sure that the time

shown is synchronized with the time shown in quad-

rant 5.

2. Turn knob 2 in the clockwise direction so that the

symbol is aligned with the marker in quadrant 4.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ariston FS 41 R Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info