Bedienungsanleitung Ariston KBT 6004 (Seite 27 von 58) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

454968

Zoom out

Zoom in

Vorherige Seite

1/58

Nächste Seite

Electrical connections

Voltage,

Frequency

Fuses,

Sections

FR-AT-BE-DE-GP--

ES-IE-IL-IS-IT-LU-

RE-FI-GB-GR-PT--

SE-MA-NZ

230V-1+N~50 Hz

25 A*

2,5 mm²

FR-BE-NO

230V-2~50/60 Hz

25 A*

2,5 mm²

FR-BE-CH-DE-AT--

ES-IL-IT-NZ-PT-

MA- LU-SE-IS-NL

400V2-N~50 Hz

16 A*

1,5 mm²

FR-BE-NO

230V3~50 Hz

16 A*

1,5 mm²

FR-AT-BE-DE-ES-

IL-IS-IT-LU-PT-SE

-MA-NZ-CH-DK-N-

400V3+N~50 Hz

16 A*

1,5 mm²

230V2+2-N~50 Hz

16 A*

1,5 mm²

CY-AU-NZ-KW-MT

240V-1+N~50 Hz

25 A*

2,5 mm²

* Application of the simultaneity coefficient in accordance with

cei 60335-2-6 norm

Technical characteristics

This appliance conforms with the following European

Community Directives:

- 73/23/EEC of 19/02/73 (Low Voltage) and subsequent

amendments;

- 89/336/EEC of 03/05/89 (Electromagnetic

compatibility) and subsequent amendments;

- 93/68/EEC of 22/07/93 and subsequent amendments;

Warning: If the hob is fitted above a built-in oven, the hob

and the oven must be connected to the mains separately for

safety reasons and to simplify operations when it is necessary

to pull the oven out for some reason.

Electrical connection

• The electrical safety of this appliance can only be

guaranteed if the latter is correctly and efficiently

earthed, in compliance with regulations on electrical

safety. Always ensure that this vital safety measure has

been taken. If you have any doubts, call in a qualified

technician to check the electrical system thoroughly.

• The manufacturer denies all responsibility for

damage resulting from a system which has not been

earthed correctly.

• Before powering the appliance, check whether the

technical characteristics featured on the appliance data

plate correspond with those of the mains electrical

system.

• Check that the current load of the mains supply and

of the power sockets is suitable for the maximum power

of the appliance, indicated on the appliance data plate.

If in doubt, contact a qualified professional.

Disconnect the appliance from the electricity supply

before all operations.

Connect your hob to the electrical system by means of a

junction box: if the appliance is connected permanently

to the mains, an omnipolar circuit breaker, accessible if

necessary, with a minimum contact opening of 3 mm

should be installed.

Valid only for models with a power supply cable

Some models are supplied with a single-phase power

supply cable, and should consequently only be connected

to the single-phase mains. Observe the wire colours, as

indicated in the diagram attached.

Electrical connections Voltage, Frequency Fuses, Sections

FR-BE-AT-DE-GR-ES-IL-

IT-NZ-PT-GP-CH-MA-LU-

IE-FI-SE-IS-GB-NL-DK

230V - 1+N~ 50Hz

CY-MT-AU-NZ-KW

240V - 1+N~ 50Hz

25A *

2,5 mm²

FR-BE-NO

230V - 2 ~ 50Hz

BR=BRUN,BL=BLEU

BR=BRUIN, BL=BLAUW

BR=BRAUN, BL=BLAU

BR=BROWN, BL=BLUE

* Application of the simultaneity coefficient in accordance with

cei 60335-2-6 norm

Valid only for models without a power supply

cable

Some models are not fitted with a power supply cable, as

the cable should be sized according to the type of electrical

connection in use (see connection table below). To connect

the cable, proceed as follows:

• Using a screwdriver, prise on the side tabs of the

terminal board cover;

• Pull open the cover of the terminal board.

12345

L1 L2

12345

L1 L2 N

12345

L1 L2 L3

12345

L1 L2 L3 N

12345

L1 L2 N2N1

12 34 5

12345

To install the cable, proceed as follows:

• unscrew the wire clamp screw and the contact screws.

• to make the desired electrical connection (see table),

use the jumpers housed inside the box. Position the

power supply cable wires according to the indications

in the table.

• once the connections have been made, tighten all the

terminal screws fully.

• Fasten the supply cable in place with the clamp and

close the cover of the terminal board.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ariston KBT 6004 Seite 27

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info